PWCToday - Recent Blogs Posts - Blogs

View RSS Feed

Recent Blogs Posts

  1. Post your custom paint

    Quote Originally Posted by dwbrevik View Post
    By next year I should finish what will be the worlds' only classic wood jet ski (unless someone can show me another one). It will be trimmed out with all of the classic stainless steel hardware including an air horn and a lighted flag staff .Click image for larger version. 

Name:	IMG_1625.jpg 
Views:	52 
Size:	859.0 KB 
ID:	567180Click image for larger version. 

Name:	IMG_1624.jpg 
Views:	54 
Size:	792.5 KB 
ID:	567181
    Attached Thumbnails Attached Images  
  2. Yamaha vx110 Deluxe low speed high rpm

    Hi everyone, I just bought a 2008 Yamaha Vx Deluxe with 35 hours on it and I have had some issues with it. I bought it from the original owner that barely used it. He didn't take care of it too well but he had basic servicing done each season at a dealer. I met the seller at the dealer and brought it home right from there. It had paperwork with it that stated that an oil change was done, new plugs were installed, and it was flushed on the hose. I was going to water test it but after seeing the paperwork ...
  3. 06 yamaha FXHO overheating ...

    Hello all..
    I need some help with my ski. I have an 06 fxho yamaha with only 50 hours on unit that seems to be overheating after 30min on the water at idle after coming down from some speed passes. I take the ski out and run on the hose and it never overheats. All of the water passages seem to be clear as I've smoke tested and vac tested. I have a good stream of water coming out of the port side piss hole when on the hose. I recently noticed the jet housings are separated a little and ...
  4. Oldie....650sx w/stuck cylynders....HELP!!

    I have a 89 650sx that I'm redoing and I can't get the cylinders off!! I've let them soak, tried a little smacking on the sides, heat, and now I just made a jig that has a 1/2 plate bolted to the cylinders and 2 6 ton jacks (1 on each side) that sit on the mounting plate, that's only starting to bend (with heat!)
    Anyone got any suggestions?

    Thanks ahead of time........
  5. 1100 95 wave raider won't carry a load and flaming into carb throat, idle is good

    Quote Originally Posted by Lilmac View Post
    Hi please help, I purchased a 95 1100 wave raider as a project for my 15 yr old, sounded good on trailer, but once in water wouldn't go over idle. I rebuilt carbs and new fuel filter and fuel pump seems good, good pulse to fuel pump, new plugs, new Boysen dual stage reeds, 3 piston skirts on reed side look good. Compression 120 on all. Checked timing at 15btdc, good, Suppose to be A RA1100T but not sure if it's a 95 engine or had been changed. Any help would be greatly appreciated? I give it
Page 1 of 161 1231151101 ... LastLast