|
-
PWCToday Newbie
Aquatrax turbo wont go above about 10mph
I have a Turbo Aquatrax that wont go above about 10mph/3500 rpm max. I replaced the turbo solenoid (based on a test procedure I found )and replaced the pump bearing that was worn out. I'm starting to lean toward the turbo. I bought this ski used and someone has been in the turbo previously (rtv on housing). The impeller vanes show signs of wear. How do you test the turbo or determine if that is the cause of my issues?
I've read some posts about error codes. Where do you find these? Is there a blink code on the instrument cluster? Sorry, I'm new to this ski.
Last edited by jackball42; 08-02-2022 at 01:43 PM.
-
Resident Guru
Re: Aquatrax turbo wont go above about 10mph
I wonder you have a exhaust leak choking the motor or bad plugs, though those other issues not good.
Compression test ?
'88 550-ride plate,intake grate,intake manfold,carb '96 GTX-1mm overbore,F/a's,intake grate,port timed for mid and top end '95 FX 1- usually take this motor to 753cc with exhaust porting and reeds
-
Resident Guru
Re: Aquatrax turbo wont go above about 10mph
check air filter if you never have
'88 550-ride plate,intake grate,intake manfold,carb '96 GTX-1mm overbore,F/a's,intake grate,port timed for mid and top end '95 FX 1- usually take this motor to 753cc with exhaust porting and reeds
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|