Hello again. 94 Polaris 750. Want to replace all fuel lines and oil lines and check valve. Are they all 1/4 size or what? Also need a carb rebuild kit. What's a good site to use for parts? Without spending a lot. This is a cheap ski. I'm also upgrading the fuel pump and replacing the fuel switch. Final question is i want to install a water temp gauge. Is there a fitting somewhere i can remove to install the temp sensor?
Few questions about fuel/oil line size and other questions
Collapse
X
-
Re: Few questions about fuel/oil line size and other questions
Fuel lines are 1/4". Oil injection lines are 1/8"
We have genuine Mikuni carb kits, and triple outlet fuel pump kits in stock here for your Polaris.
I understand NOT wanting to spend a lot of money on an in expensive ski, BUT please know you get what you pay for. If you cannot afford to do it right the 1st time, you sure cannot afford to do it over, or have issues causing an engine failure from a lean condition. Stick with genuine parts.......
John - www.watcon.comRCJS also doing business as WATCON
608-743-1305 9am to 5pm CST m-f
email [email protected]
Please visit our web site
new parts / products / services www.watcon.com
thank you
Please check out and like WATCON on Facebook
-
-
Re: Few questions about fuel/oil line size and other questions
There should be a plug over the rear head on the water rail.http://www.facebook.com/twinlakesjetskirepair
'89 Kawi 650SX 42.4 GPS
+3" stock pipe, ported ex. manifold, drilled waterbox, blueprinted pump, Ocean Pro ride plate
'99 Yama GP1200 65U 61.8 GPS
ported cylinders, matched cases, milled head, blueprinted pump, long ride plate
'96 Seadoo HX 717 53.13 GPS
light porting, massaged cases, lightened flywheel, port matched manifolds, Rossier pipe, stubby pump cone
Comment
-
-
Re: Few questions about fuel/oil line size and other questions
Originally posted by fijiblue View PostDo you know about a port somewhere i can install a temp sensor on the block?RCJS also doing business as WATCON
608-743-1305 9am to 5pm CST m-f
email [email protected]
Please visit our web site
new parts / products / services www.watcon.com
thank you
Please check out and like WATCON on Facebook
Comment
-
-
Re: Few questions about fuel/oil line size and other questions
It has a alarm. Not a gauge. I want to install a water temp gauge. I don't trust the alarm. Especially with my future plans for this pile. I paid 300 for it so I'm not attached lol. Thanks for the input fellas
Comment
-
Comment