Todays update,

All new cooling lines installed, new 4 into one installed and everything back together... everything runs but still water getting into the hull. no leaks from the lines that I can see. I even broke down and found a replacement meter for $600.

I am probably replacing the thru hull bearing fitting next.

My troubleshooting plan is to fill the hull with water tomorrow to see where it is coming out from. I think if it has a leak at the bearing fitting once it gets under water it may start dripping. I am going to double check the thru hull fittings to the pump to make sure they are not cracked. Frustrating to be so close to fully operational.

Plan on plugging along till I solve this issue