Head gasket for 650 cylinder bored +2mm

[timmymac]

Like title says - anyone have a source for stainless head gaskets to fit 78mm bores? The stocker overlaps into the bores and I have the squish set up for stock gasket thickness so I'd rather not go with a fiber .040 gasket.

I could grind back a stock gasket to fit the 78mm bore, but then it would lose the crimped/raised area around the cylinders. Is this a problem?

[BLRider]

You could use a stock 750 head gasket (80mm) or call Conetic.

[timmymac]

The 750 has the same cylinder spacing and bolt pattern then? That seems like the best choice, thanks.