Search:

Thank you very much. Sorry did not respond earlier, did not get a chance to read my mail. I purchased the solenoid, will let know when i replace it.

I tried to start this jetski and starter began running on its own. I took off the shutoff lanyard from the switch but the starter kept cranking. The battery terminal broke off and removing the cable...

Thank you guys. Now i know where to start.

I bought a 1994 Seadoo SPi. It was starting and running when I was testing it and afterwards every time I started it in the storage. Inside of th he engine compartment fuel smelled old, but I thought...

Looks like I found it, SEA-DOO SAFETY SWITCH NUT 278000099

I purchased 1994 Sea-Doo XP. It is running fine but is missing the top of the kill switch button and the key does not latch to the button anymore. Tried to find it anywhere online, ebay, offerup,...

Today I made a huge mistake, I allowed my daughter and her boyfriend to go alone on my jetski. Hour later they both came back without the jetski and told me that it stalled and they left it with some...

I changed the speed sensor a couple years ago, since it was not working all the times. It worked on the start, first several minutes and then was showing speed intermittently. I bought an aftermarket...

Thank you very much, will try it today.

So far the only water incoming was from the coupler. When I replace the coupler, I'll definitely look for possible other sources. The most important question for now is where to get a coupler...

thank you, I ve got it running in a still water without a seat and found that the exhaust hose through hull coupler was broken, cracked on the bottom not enough to fall off completely but enough to...

I took my jetski to the lake and noticed significant amount of water in the engine compartment. In about an hour of riding it got about 7-8". First I drained it and let it stay in the water for 10-15...

I have kawasaki 1998 750zxi jetski. it has a problem with speedometer pickup, when I just start it, it sends a signal to speedometer for a couple minutes, but as I ride further it stops working. I...

504164504165

Anybody knows where can I get a manual for this PWC? I just bought one and need to install the engine. Thank you.

I got a new wheel, still the problem persists

I get an intermittent problem with getting a signal from speedometer pickup. When I start the craft it shows up speed for a little while, but after about 2-3 minutes, sometimes a little longer the...

yep the gauge has only oil light, no dial. As for removing the baffle, do i need empty the fuel tank and move it first or does the baffle have enough clearance to take it out without moving the tank?

I recently bought 1997 Seadoo Bombardier GTs and the fuel/oil gauge does not work on it. When I plug the key the fuel hand moves a bit and stays close to 0. I wondered if there is any easy way to...

it started today and i ran it the lake for an hour or so, will take it to the lake tomorrow as well. The needle and the seat were good so neither I or mechanic replaced it. will see how it goes...

Got a new old 95 Seadoo, could not start it. Rebuild carburetor, filter was very dirty. Changed it, started ok, ran it once and again next day the same story, does not start. Took it to mechanic,...

hmmm, Im overwhelmed with the number of responses, guess Im better of asking my mechanic. Thx guys.

I purchased recently a couple Seadoo jetskies. One is 97 Bombardies GTS and the other is 95 Bombardier and I cannot find what is the model of the later one. 97 has only a Fuel level and Oil warning...

I took my jet ski to the mechanic and he offered me to remove the oil pump and the oil tank and instead fill up the tank with premixed gas/oil mixture. Is it worth doing or not? Mechanic said it...

It was the ignition coil problem, as soon as i put a new one I got a strong spark and it starts every time.

470703470704
These are the wiring diagram and the harness pic, I think ZXi 900 and 750 have very similar harnesses and there is a little ground wire that has to go on the negative terminal of the...

The oil/water temp warning lights do not lit on startup. Also the speedometer worked for the first 10 mins at the first start after a long storage and died. I changed the electronic control unit,...

Thank you,
looks like this project gets more and more interesting :) The rags I put close to the flame arrester ducts, this way they were sending some gas into the carburetor but were not getting...

Is it the same electric control unit as a trim control unit? It looks like it is the only control unit I can find, will have to go through wiring later today, to trace where do the wires from the...

actually it was not such a hard task. as soon as i found 2 bolts holding the hood inside of the storage compartment, removing them and 2 bolts up front did all the work. I had to spend a couple...

Trim control works ok. Fuel gauge shows 3/4 of a tank - this is most likely the fuel tank floater sensor problem, will have to pull it out of the tank and inspect. Speedometer, most likely the...

Checked out the resistance in ignition coil. That was the faulty part. Will update when replace it.

I tried to start the PWC but it just cranks the stator and did not ignite. Started once and then died again. Wasnt able to start it since. Started looking into the spark plugs, does not have any...

Warning lights are dead, how do i get to them. Seems like I need to remove the engine hood. What are the steps to do this, do I need to remove the steering wheel or handle bar? I have Repair and...

Thx, the Oil and temp indicator or warning lights did not turn on when i turned the key on, the other controls I'll test today. Do i need to change the whole warning lights assembly or is there a way...

Took the watercraft for the first ride yesterday, it runs great after 14 years of sitting in the driveway, cleaned up the fuel system with Sea foam. However there are a couple problems with the fuel...

Thx, used a lot of grease and was able to change them, 2nd one was much easier than the first.

Im trying to change a couple broken joints (plastic threaded pieces that waterproof the control box and have wires going through them). I changed the joints for the wire lead for trim meter and...

Two questions,
1. The rubber traction mats are peeling off, what should I use to clean the old gunk off and what glue should I use to glue it back?
2. The front traction mat, really thin one that...

It actually started! My friend got two pieces of cloth, soaked them in gas and put them to the sides of the carburetor and when i turned the engine on it started and kept going. Now I need to add sea...

Lanyard is in place, and gas is in the tank. I suspect the fuel lines are clogged and will try to clean them from the debris. Will see if that will help

First thing I checked, both fuses are good. I still replaced them with the new ones

I got a watercraft from my friend kawasaki zxi 750 1995. It was not used since 2001 and was sitting in his driveway. I got a new battery, gas tank was empty but clean, so I filled it and tried to...