Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: Spades; Keyword(s):

Page 1 of 9 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    1
    Views
    201

    Re: 2009 STX 15F No Fuel but new pump! ECU?

    I think you ordered the ECU too soon, there are still couple items to test before proceeding to the ECU. First there is a fuel pump relay that you need to verify, and also there is a Vehicle Down...
  2. Replies
    3
    Views
    267

    Re: 951 external rectifier

    UPDATE: At first i thought the coil made no difference, but i noticed that it could run (slow) on the rear cyl only, but wouldnt run at all on the front cyl only. Now it is able to run on the front...
  3. Replies
    3
    Views
    267

    951 external rectifier

    Im getting symptoms of either a bad rectifier or stator. Runs fine for a minute then starts bogging down. Shut it down for about 15 seconds and it runs ok again for about 20 seconds. Once the bogging...
  4. Replies
    4
    Views
    239

    Re: 951 thermo sensor switch?

    So neither of these sensors will send it to limp mode? Or is there even a limp mode function on 99+ 951 carb engines?
  5. Replies
    4
    Views
    239

    951 thermo sensor switch?

    In the manual i see 2 temp switches. One is a Thermo sensor switch, and the other is a water temp sensor? Is the Thermo sensor switch used overheat? If so, what is the Water Temp sensor used for?
    ...
  6. Replies
    14
    Views
    14,811

    Re: PWC Trailer Winch post where to find?

    I made my own several years ago out of 1/2" x 2" hollow 11 ga' square tubing (I know its a rectangle :]) and welded it up, worked fine for many years. And just buy the winch and bow stop
  7. Replies
    58
    Views
    16,525

    Re: STX 15F Starting Problem when hot

    Yes that is exactly how a momentary switch would work
  8. Replies
    3
    Views
    614

    Re: PWC fuel consumption numbers in one chart

    Very useful, however id like to see distance at a certain mph (ie 35mph) per gallon, since different skis have different size gas tanks, and WOT isnt a fair comparison either because one ski has a...
  9. Replies
    57
    Views
    4,516

    Re: Wtf is it w everyone wanting 4 strokes?

    I own 1 of each. It isnt so much the 2-stroke 4-stroke thing for me, its the carburetors vs EFI. We ride at Lake Mead and Mohave where 2 strokes are banned, and sometimes high elevation at Big Bear...
  10. Thread: Ultra 150 parts

    by Spades
    Replies
    5
    Views
    429

    Re: Ultra 150 parts

    ttt
  11. Replies
    14
    Views
    784

    Re: STX 1100 reverse cable

    Dang, this thing is still here
  12. Replies
    14
    Views
    784

    Re: STX 1100 reverse cable

    ttt
  13. Thread: Ultra 150 parts

    by Spades
    Replies
    5
    Views
    429

    Re: Ultra 150 parts

    still for sale
  14. Thread: Ultra 150 parts

    by Spades
    Replies
    5
    Views
    429

    Re: Ultra 150 parts

    ttt
  15. Replies
    14
    Views
    784

    Re: STX 1100 reverse cable

    ttt
  16. Replies
    3
    Views
    481

    Re: Anyone have high res Seadoo logos

    Yes excellent, thank you. How about some colored ones as well?
  17. Replies
    22
    Views
    2,722

    Re: 951 fuel line replacement

    Dang, that will leave you with extra for a whole other ski... I used 12ft of 5/16" and 5ft of 1/4"
  18. Replies
    3
    Views
    481

    Anyone have high res Seadoo logos

    Does anyone have any high resolution Seadoo logos and willing to share them?

    Thanks!
  19. Replies
    4
    Views
    460

    Re: Is this genuine Mikuni diaphragm?

    Awesome! i will proceed with installing them today, Thanks guys
  20. Replies
    4
    Views
    460

    Is this genuine Mikuni diaphragm?

    Bought from eBay as genuine. It has the red dot in the middle, but on the other side, one has a small red dot that sticks up about .025" while the other is not red and only sticks up about .015"....
  21. Re: seadoo multifanctional gauge center install on xpl

    Ive done a conversion using 97 GSX 787 multi-function gauge onto my 99 GSX Limited. You will have to read up on the schematics on both skis, and would be wise to print them out so you can compare...
  22. Re: Seadoo 951 carb intermittently dies/shuts off

    if it is shutting down wouldn't it have to be extremely lean? Slightly lean would seize it without warning
  23. Replies
    9
    Views
    764

    Re: Doubling up on oil mix?

    on a brand new ski, seadoo says to premix in addition to oil injection during the break-in period. So id have to believe that it is safe to premix
  24. Re: 1996 seadoo gts water coming in through driveshaft boot help

    The leak stopped because you have more pressure applied between the steel flange and carbon ring surfaces, but that is not the correct method there. What you can do is loosen the rear most clamp and...
  25. Replies
    3
    Views
    295

    Re: 99 GTX Limited Low Fuel reading?

    Yes the ski will run regardless of the fuel sending unit and/or the gauge functions
  26. Installing pump cone with anti-rattle mechanism

    After removing the pump cone and reinstalling on a 2001 RX the impeller spins rather tight. I loosen the cone and the impeller shaft spins freely again... So after doing some research i came across...
  27. Replies
    3
    Views
    402

    Re: Better wave jumper & top speed combo?

    Yeah i think i will pick up an XP, however im opening up to the 787. I was originally avoiding them due to maintenance and reliability compared to the 720 but i guess it isnt too bad. I do have the...
  28. Thread: 96 787 jetting

    by Spades
    Replies
    7
    Views
    460

    Re: 96 787 jetting

    96 787 didn't have accel pumps to delete.

    By primer, are you meaning choke plates removed? If so i had that exact setup and changed only the LS jet to 85s. Oem pop off
  29. Thread: Ultra 150 parts

    by Spades
    Replies
    5
    Views
    429

    Re: Ultra 150 parts

    ttt
  30. Replies
    3
    Views
    402

    Better wave jumper & top speed combo?

    Looking for a decent 2-cylinder wave jumping ski, with top speed being secondary. With that ive found ZXI750 Raider760 XP720 to be my choices. Which of these 3 would be better-best suited for...
  31. Replies
    8
    Views
    465

    Re: Info gauge issue

    Id be willing to bet that it is the oil level, fuel level, and vts are failed. All are common Seadoo failure points.
  32. Replies
    5
    Views
    320

    Re: Detune RXX for reliability?

    Id be keeping the pipes & pump for special occasions :-P

    Are the engine specs any different? port shapes? pistons and/or compression ratio?
  33. Replies
    8
    Views
    465

    Re: Info gauge issue

    Looking at the schematics i see 8 wires, but i cant tell which wire(s) serves as the position signal. All i know is the Black (-) and the Red-Purple (+)

    ***On second thought, i just looked at the...
  34. Replies
    5
    Views
    320

    Detune RXX for reliability?

    What would it take to detune an RXX for better reliability? Lowering compression, pitch down on the impeller to match the new lower power. How would it run? Any other methods? Is the engine specs any...
  35. Replies
    8
    Views
    465

    Re: Info gauge issue

    Well, it would not necessarily solve the gas gauge issue yet, youre still trying to determine if its the gauge or the fuel baffle. If it happens to be the gauge then it could may well cause the vts...
  36. Replies
    8
    Views
    465

    Re: Info gauge issue

    If you disconnect the fuel level sensor harness, and short the side going to the mpem the gauge should read full. If so, the problem lies in the fuel baffle
  37. Replies
    14
    Views
    784

    Re: STX 1100 reverse cable

    Or trade for 15F reverse cable
  38. Replies
    14
    Views
    784

    Re: STX 1100 reverse cable

    ttt
  39. Thread: Ultra 150 parts

    by Spades
    Replies
    5
    Views
    429

    Re: Ultra 150 parts

    ttt
  40. Replies
    14
    Views
    784

    Re: STX 1100 reverse cable

    ttt
  41. Thread: Ultra 150 parts

    by Spades
    Replies
    5
    Views
    429

    Ultra 150 parts

    Parting out 2001 Kawasaki Ultra 150, 1200cc 2-stroke. All original

    Head - $20 (1 left)
    piston - $20 (1 left)
    Crankshaft - needs rebuild - $80
    Exhaust system with waterbox - $50
    starter - $50...
  42. Replies
    14
    Views
    784

    Re: STX 1100 reverse cable

    ttt
  43. Replies
    10
    Views
    456

    Re: common failures on 951 DI engines

    thank you for all your help.

    How about using seafoam in the fuel system? good or bad idea?
  44. Re: Help me decide which ski to buy 02 Seadoo RXDI or 02 Yamaha XLT800?

    Ive had a bone stock GP1200 (same engine) and didnt do the carb balance mod, and it ran just fine. And doing the mod does nothing to the bottom end of an engine.
  45. Replies
    10
    Views
    456

    Re: common failures on 951 DI engines

    what is some good preventive maintenance that I can do for the air and fuel injectors? Stabilizers, seafoam? I plan to install a new fuel filter immediately.

    And are the original fuel lines the...
Results 1 to 45 of 390
Page 1 of 9 1 2 3 4
Powered by vBadvanced CMPS v4.2.0