Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: jball140; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    12
    Views
    7,252

    Re: 2006 155 Wake edition Engine Code problem

    What did you find? I am having the exact problem on 05 GTX wake. Thanks for any help given
  2. 05 GTX Wake beeps once when put llaynard on

    05 GTX put laynard on and get 1 beep then beeps to tell lanyard left on. The problem is intermittent. had new key programmed no help. SBT scanner showed P1655 dess post line shorted and P0616 starter...
  3. Replies
    8
    Views
    1,020

    SBT fuel valves

    Replaced fuel valve on 1997 GTX and fuel valve failed next time out. Replaced with another SBT pn 35-101 and did the same again. When turn selector knob it is hard to turn and will not run past...
  4. Replies
    0
    Views
    567

    OPAS valve replacement

    How do you remove OPAS valve from 04 GTX. I have all hoses off and cannot get valve out of hull. Thanks for all replies
  5. Re: Wear ring for 1996 GTS with 140 mm aluminum pump

    Found the problem. Aluminum pump uses smaller OD wear ring. When ordering tell SBT that you need wr for aluminum pump and they will send the correct one. SBT was very helpful....
  6. Re: Lake Ozarks..Need some help/info 1998 GTX wear ring

    If it has the origional pump check to see if there is washers on the mounting studs. If washers not there it may cause pump housing to warp when tighten. If you have never removed a pump go to...
  7. Replies
    1
    Views
    770

    Needle and seat question on 96 GTI 717

    Hello Mr. Bill,
    Rebuilding carbs on 96 GTI 717 and has 1.2 needle valves. Can I replace with 1.5 and will it effect pop off too much?

    Thanks for all the help you given me.

    Jim
  8. Wear ring for 1996 GTS with 140 mm aluminum pump

    Replacing wear ring on 96 GTS with 140 mm aluminum pump housing. I removed old WR and cleaned inside of housing. Put new OEM WR in freezer and when fit into housing it was tight at first and halfway...
  9. Replies
    2
    Views
    1,072

    Re: check engine alarm 2003 GTX 185 SC

    Removed the speedo/temp sensor and found mouse had chewed on wires. Repaired cable and still bad. Replaced with new sensor and now working. Also replaced the crankcase pressure sensor and no CK Eng ...
  10. Replies
    10
    Views
    1,152

    Re: 951 pop off at 12 psi max

    Recently purchased jet kit from Bill and Chris at watercraft magic with 2.3 needles. Used the springs they they sent and pop off was clean and crisp at 20 lb. Hope this helps
  11. Replies
    2
    Views
    1,072

    check engine alarm 2003 GTX 185 SC

    After 20 minutes got CK ENGINE alarm, went into 5000 rpm limp mode, cleared out and happen again 5 minutes later.

    SBT scan tool shows Lake Temp Circuit out of Range High Voltage and comes back on...
  12. Re: LH Resonator P/N 274000484 Question (02 GTX 787 RFI)

    Speedracer could you please tell me what causes the resonator to burn a hole in it and is there any way to prevent. Thanks for your reply. jball140
  13. LH Resonator P/N 274000484 Question (02 GTX 787 RFI)

    Has anyone had a problem with the left hand side exhaust resonator going bad in a 2 stroke Seadoo. Working on 2002 GTX 787 RFI and it looks as if it got hot and has a 2 inch round hole in the bottom...
  14. 1997 Seadoo Speedster driveshaft question

    What is the purpose of retaining ring pn 204120132 (plastic tube that goes around drive shaft on 1997 seadoo speedster twin engine jet boat) ? Can you run without it ?
    Thanks for all replies.
  15. Replies
    1
    Views
    541

    Oil for 2002 FX140

    What weight should I use for 2002 FX140? Thanks for all replies.
  16. Re: 2000 GTX 787 RFI excessive white smoke at start up

    Hey Mr.Bill, Found out my new battery was not fully charged. Put in a good fully charged battery and charging system started working. Took ski to lake and ran it hard and now not smoking much. Seems...
  17. Re: 2000 GTX 787 RFI excessive white smoke at start up

    Thanks Mr. Bill I will replace and see.
  18. Re: 2000 GTX 787 RFI excessive white smoke when running

    I have Pressure tested the RV cavity and it held 5 psi for 30 minutes. Also to check for too much fuel put an inline pressure guage in fuel line. Got 58 psi at key on, about 50 running and does...
  19. Replies
    1
    Views
    559

    62 T engine size

    What cc is the Yamaha 62T motor. Thanks for any help given, Jim
  20. Replies
    3
    Views
    754

    Re: yamaha carb settings

    Tom, thank you very much. I was having a hard time finding this info. Jim
  21. 2000 GTX 787 RFI excessive white smoke when running

    2000 GTX 787 RFI emits excessive white smoke. I have pressure checked the RV cavity and it held pressure OK. I seems as may be getting too much fuel. I do not have a BUDS and was wondering if any of...
  22. Re: 2000 GTX 787 RFI excessive white smoke at start up

    Thanks for the quick reply. Is it possible to Pressure Test RV cavity to be sure? If so what is max pressure to be applied. Thanks for your time.
  23. 2000 GTX 787 RFI excessive white smoke at start up

    Hello Mr. Bill, have 2000 GTX 787 RFI that fills shop with white smoke at start up. Battery is fully charged , but does not seem to be charging. Clipped plug wires. Pulled some gas from tank and it...
  24. Replies
    3
    Views
    754

    yamaha carb settings

    Need carb pop off, spring size , low and high settings for 2001 yamaha XL 800. Going to build the carbs and cannot find the settings. Thanks for any help given.
  25. Replies
    0
    Views
    1,067

    2001 Yamaha XLT 800 pop off specs

    Ski will not rev over 4500 and does not get on plane...Need to know what pop off , high and low adjustment settings for 2001 XLT 800. Done a few Seadoo but do not have anything on Yamaha. Thanks for...
  26. Replies
    4
    Views
    802

    Re: Need Help. 98 GSX Electrical Problem

    Mr. Bill, It kicks out and not sure if stops spinning. Will try to find a friend with same MPEM to try. I think 98 GTX might be same.Thanks for your time.
  27. Replies
    4
    Views
    802

    Re: Need Help. 98 GSX Electrical Problem

    Mr. Bill, Today I unplug connector to stator and hit start button and starter will spin as long as I press start. Not knowing history of ski I am wondering if rotor mag cup may be wrong part or...
  28. Replies
    4
    Views
    802

    Need Help. 98 GSX Electrical Problem

    Hello Mr. Bill, working on 98 GSX 951 carb ski that was just purchased.I have no history on ski. When trying to start it turns over about 1 or 2 turns and starter stops, press switch again and does...
  29. Replies
    3
    Views
    1,583

    Re: Yamaha VXR Reverse Lever is hard to lift up

    Thanks to all. Sounds like an easy fix.
  30. Replies
    3
    Views
    1,583

    Yamaha VXR Reverse Lever is hard to lift up

    2012 VXR have trouble when try to lift reverse lever. When lever does finally release it is smooth and seems fine. Seems like it is locked. Just is very hard to lift up at first. It was OK at first...
  31. Replies
    14
    Views
    4,297

    Re: 1998 GTX 787 RFI fouling plug on #2 cyl

    Thanks Mr. Bill, clipped plug wires, put in a can of Seafoam, ran it hard for 10 minutes
    then rode at idle 5 minutes and rode 20 minutes. Ran OK, Pulled plugs and they looked good. What is your...
  32. Re: Red warning lamp in analog tach side of 96 GTX

    Thanks I will try that. The beeper is bad and I plan to fix when I get time.
  33. Red warning lamp in analog tach side of 96 GTX

    On a 1996 GTX 787 carb ski a RED warning lamp has lit up in the analog tachometer while riding. The symbol looks like a thermometer... Placed hand on the motor and did not seem to be overheating....
  34. Replies
    14
    Views
    4,297

    Re: 1998 GTX 787 RFI fouling plug on #2 cyl

    Thanks Oasis Performance. I will see if it smokes too much at start up. My guess is it is getting more fuel than air on the rear cylinder, but if I knew for certain I would not need help. Do you...
  35. Replies
    14
    Views
    4,297

    Re: 1998 GTX 787 RFI fouling plug on #2 cyl

    Thanks billse86e. I will clip the wires. Does the 787 RFI have a water seperator. I know it has electric fuel pump and filter for pump, but have not found seperator.
  36. Replies
    14
    Views
    4,297

    1998 GTX 787 RFI fouling plug on #2 cyl

    1998 GTX 787 RFI fouling plug on rear cylinder. Looks to be fuel fouled but not sure. Here is what I have checked so far.
    Voltage regulator is charging at 13.8 VDC
    Rave valves look OK and are...
  37. Replies
    1
    Views
    1,777

    1995 Seadoo Sporster 657X wiring diagram

    Need wiring diagram for 1995 Seadoo Sportster Jet Boat with the 657X engine. The MPEM has been spliced into and the wire colors do not match up. Have tried but can not find the 1995 year. Thanks...
  38. 2006 VX110 fuel Pump/Fuel Sender Question

    Have 2006 VX110 Deluxe that fuel sender seems to be stuck or broken. When first put laynard on and hit start all segments light up and drop to two segments and alarm will sound. Problem is I have a...
  39. Replies
    1
    Views
    1,878

    2006 VX110 fuel Pump/Fuel Sender Question

    Have 2006 VX110 Deluxe that fuel sender seems to be stuck or broken. When first put laynard on and hit start all segments light up and drop to two segments and alarm will sound. Problem is I have a...
  40. 2006 VX110 fuel Pump/Fuel Sender Question

    Have 2006 VX110 Deluxe that fuel sender seems to be stuck or broken. When first put laynard on and hit start all segments light up and drop to two segments and alarm will sound. Problem is I have a...
  41. Replies
    2
    Views
    696

    951 Stator replace questions

    2000 GTX 951 blowing 15 amp rear fuse. Mr. Bill and Jason was right on with bad stator. I could see the burn marks on stator. I saw very little shavings and was dry inside. I plan to replace bendix...
  42. Re: Help...Blowing 15 amp fuse in rear electrical box

    Thanks very much for the fast info. I enjoy reading your post daily. I seldom need help, but when I do I find this site very helpful.
  43. Re: Help...Blowing 15 amp fuse in rear electrical box

    Thanks very much for the fast help. I enjoy reading your posts.
  44. Help...Blowing 15 amp fuse in rear electrical box

    2000 Seadoo GTX 951 carb freshwater ski in clean condition. 15 amp fuse blows when touch pos battery post. Battery is hooked up correct. Things tried that did not help. Tried another good...
  45. Replies
    3
    Views
    1,337

    Re: HELP... Need carb info. 95 SPX

    Thank you very much for your fast reply. I feel confident now that the rebuild will go right.
Results 1 to 45 of 57
Page 1 of 2 1 2
Powered by vBadvanced CMPS v4.2.0