Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: keck; Keyword(s):

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Re: 750ss Xi Return Fuel Line — where to connect?!?

    Would love some help on the post above -- anyone?
  2. Ski dies if let of throttle… easily starts again

    1992 550sx dies off if throttle is let up. Sometimes I can hit the green button and get it going before sinking too far into the water. Ski has primer and starts and runs easily. What do I need to...
  3. Replies
    3
    Views
    1,061

    Re: Hydroturf Standup Rails

    . Looks really clean!
  4. Replies
    3
    Views
    1,061

    Hydroturf Standup Rails

    When you hydroturf standup jet ski rails… do you glue the top and outside and then use a straight blade to trim the rest, or do you fold the rest under and try to adhere to the inside of the inner...
  5. Re: 750ss Xi Return Fuel Line — where to connect?!?

    Following to to posts above — finally got 750ss xi in the water (and had to be towed) ��. When I primed it, I get ski to start right away. Yet would only run low rpms until it ran out of gas. When...
  6. Re: Adding Primer; yet close off pins not fitting...

    Used JB Weld “Steelstick”
  7. Re: Adding Primer; yet close off pins not fitting...

    Smart -- thanks
  8. Adding Primer; yet close off pins not fitting...

    Adding primer to Kawasaki 750ss xi; yet close-off pins not fitting the carbs where the choke was removed. I can push them in, but they are loose. On the 750sx... they were snug and had to be tapped...
  9. Re: 750ss Xi Return Fuel Line — where to connect?!?

    Thanks — I’m heading down that path as well. This ski has been sitting under a tarp for years. I’ve drained the gas, converted to premix, block-offs, etc.
  10. Re: 750ss Xi Return Fuel Line — where to connect?!?

    Return line is clean and in good shape.
  11. Re: 750ss Xi Return Fuel Line — where to connect?!?

    Assume my next step is to replace the fuel lines and ensure nothing is clogged. Anything else you recommend.
  12. Re: 750ss Xi Return Fuel Line — where to connect?!?

    Yes. Didn't have starter fluid at home, so poured some 40:1 mix into the holes and replugged and it started up and died out quickly. Wouldn't restart after the initial burst.
  13. Re: 750ss Xi Return Fuel Line — where to connect?!?

    I have the engine re-installed and it cranks hard, but I can get it to fire up. Wondering if I misassembled something as it doesn't appear to be pulling fuel through the line. Maybe I thought I had...
  14. Re: 750ss Xi Return Fuel Line — where to connect?!?

    Ok, think I got it.
  15. 750ss Xi Return Fuel Line — where to connect?!?

    I pulled my engine to perform the block offs and to replace the trim cable. Got it back together yet forgot where to connect the return fuel line. Where do I connect?
  16. Replies
    29
    Views
    2,653

    Re: What is the best year for SuperJet?

    Assume cause the SuperJets are more stable?
  17. Replies
    29
    Views
    2,653

    What is the best year for SuperJet?

    I’m sure this is super subjective; yet is there a “best “ year for SuperJets? Of course I’m interested in the latest and greatest... however also respect the early years when the skis were lighter...
  18. Replies
    4
    Views
    1,524

    Re: Dealership Negotiation

    The pandemic isn’t helping with the prices due to the increased demand.
  19. Replies
    4
    Views
    1,524

    Dealership Negotiation

    My skis are all from the 90's... so haven't been into a dealership lately :). Thinking about a new stand up and an UTV. Is the buying process similar to a car where you go through the negotiation...
  20. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    Hi! Model is 1994 Kawasaki 750ss xi. I believe this was the first year with the electric trim module and gauge. Photo below shows the yellow and black wires going directly into the module (likely...
  21. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    Thank you “OldGuy” — much appreciated. If anyone else has experience swapping out the OEM trim module with the black and yellow wires (in addition to the blue green connector), please chime in. The...
  22. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    The part I ordered online has only the blue and green cable connector (noted for 1994 model). The OEM version had several other cables going into the module. Are these still needed? Wanting to ask...
  23. Replies
    6
    Views
    599

    Re: WTB 1994 Kawasaki 750ss xi trim module

    Planning to purchase a new piece and hook it up to keep moving. Thought out converting to a manual trim like the 93 model... wondering if anyone else has gone down that path.

    564072
  24. Replies
    6
    Views
    599

    Re: WTB 1994 Kawasaki 750ss xi trim module

    The unit was likely "shot" already as I had to clean up quite a bit of corrosion and didn't get results when I hooked up a 12v. Also, I made a mistake of trying to unscrew the gear bolt and think I...
  25. Replies
    6
    Views
    599

    Re: WTB 1994 Kawasaki 750ss xi trim module

    Not sure this is the photo you requested; however, I don't think electrical is my issue (will explain in next post). 564066
  26. Replies
    6
    Views
    599

    Re: WTB 1994 Kawasaki 750ss xi trim module

    Hi, What do you mean when you say “electrical connectors”? Happy to provide photos if you’re re able to help. Trying to repair this ski for my father.
  27. Replies
    6
    Views
    599

    WTB 1994 Kawasaki 750ss xi trim module

    WTB 1994 Kawasaki 750ss xi trim module. Looking for the part that goes in the ski hull, not the handlebar.

    564022
  28. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    Thanks for the responses. Please help clarify which two wires you are noting to connect to the battery. I can also try a multimeter. I know the green and blue wires that control the up and down. ...
  29. Re: How to remove water from bottom of 550sx hull after riding?

    Ok, makes sense... better than leaving the water inside,
  30. How to remove water from bottom of 550sx hull after riding?

    How do you purge out the water that resides in the hull of a 550sx after riding? In this case it’s ~1-2” in spots. I know some got in from the round air opening in the hood.
  31. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    Thanks for the response! When I pull the trim motor out... it's easy to turn. Yet when I push it back in and have it try to turn the gear I run into the tightness. I've cleaned and lubricated the...
  32. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    Please help here... not sure of my next step to resolve the trim issue. Seems that this is a common problem. Tried to resurrect this thread from the past instead of starting new.
  33. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    I've undone the trim box and opened up the motor. The motor is hard to spin; yet I can move it by hand if I twist hard. If I pull it out a bit... it spins much more freely. Is this normal? When I...
  34. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    I have the trim unit out and ready to hook up a battery to see if it works. So far I’ve connected the negative to the green and positive to the red. Nothing moving. Is it correct to connect the...
  35. Replies
    55
    Views
    23,181

    Re: Kawasaki 750 Electric Trim problem

    Bump to keep this thread alive
  36. Replies
    23
    Views
    7,616

    Re: 93 750 SS/xi engine removal?

    Ok, carbs are off; yet still having difficulty getting the engine out. Thought I'd post again before "forcing it". Do I need to tilt the engine on it's nose and pull it out vertically to avoid the...
  37. Replies
    23
    Views
    7,616

    Re: 93 750 SS/xi engine removal?

    Do you have to remove there carbs to get the engine out? I've got everything disconnected; yet can't get it to come out (keeps getting hung up in areas).
  38. Replies
    17
    Views
    5,395

    Re: 94 750 SX oil injection block off

    Know this is an old post; yet avoiding starting a new thread. Given that the Xi has electrical wires that run to the oil light on the dash... what do you do with these wires once you remove the oil...
  39. Replies
    5
    Views
    600

    Re: How to Remove Grips from Kawasaki 750SSxi?

    Dremel and cutting blade made this easy!
  40. Replies
    5
    Views
    600

    Re: How to Remove Grips from Kawasaki 750SSxi?

    Eeeks, that was what I was hoping to avoid (yet knew pretty well that was the path :) ).
  41. Replies
    5
    Views
    600

    How to Remove Grips from Kawasaki 750SSxi?

    Anyone have a tip for removing grips from Kawasaki 750SS Xi? Just realized that they handlebar has a cap at the end and that the OEM grips are glued on all around. Been cutting and peeling and it...
  42. Replies
    2
    Views
    771

    When to Replace Throttle Cable?

    How do you know when to replace a throttle cable? 1992 550sx -- cable looks fine (not frayed, not kinked, etc); however, installed new finger pull throttle and now doesn't have enough tension to...
  43. Replies
    3
    Views
    956

    Re: Jettrim 550sx Installation (side panels)

    Thanks — looks clean
  44. Replies
    24
    Views
    5,694

    Re: Removing 550 SX side pads??

    Realize 2015 post; yet "hoping" for response. Would the foam have worked if you brushed over it with Gluvit fiberglass resin a few times?
  45. Replies
    3
    Views
    956

    Jettrim 550sx Installation (side panels)

    The 550sx has concaves in the side panel fiberglass... so the Jettrim panels will have waves if I try to adhere to the surface. The concaves have to be filled to have a smooth surface, right?

    I...
Results 1 to 45 of 172
Page 1 of 4 1 2 3 4
Powered by vBadvanced CMPS v4.2.0