Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: john zigler; Keyword(s):

Page 1 of 196 1 2 3 4

Search: Search took 0.47 seconds.

  1. Replies
    1
    Views
    70

    Re: X2 Driveshaft

    I have new here. $299 + ship;

    https://www.watcon.com/jet-pump-drive-line/drive-shaft/x2-drive-shaft

    Used is getting difficult to find, and they have been going for $200-$250 used...
  2. Replies
    5
    Views
    146

    Re: Stalling 750 SXI Pro (new purchase)

    It will be warm, but not super hot (Sizzle water).
  3. Re: Possible Charging issue. Strator / Regulator?

    I have not personally ever seen this, but it has been a while since I have had a Polaris in the shop.
  4. Replies
    3
    Views
    129

    Re: Help ?Wave Blaster No Start No Click

    If the engine turns by hand, you need a multimeter and start checking where you do, and don't have power. Test the switch, start relay, battery cable at the starter, etc.
  5. Replies
    3
    Views
    129

    Re: Help ?Wave Blaster No Start No Click

    Grab the PTO coupler, and try to turn the engine by hand.
  6. Re: Possible Charging issue. Strator / Regulator?

    Don't think I have EVER seen 14.5 volts on any old PWC charging system while running...…

    13.5 would be fine, and is an increase over 12.5. Our charge systems are weak and do not charge much....
  7. Re: Superjet runs, but won't shut off. Advice needed!

    Clean all corrosion in the e-box.

    We also see this and many times it is the black/white wires at the plug connection. You cannot just look at it, you NEED to pull the pins / receptacles, and...
  8. Replies
    5
    Views
    146

    Re: Stalling 750 SXI Pro (new purchase)

    Is it still acting like a lean condition? (Your original description sounds as you were lean, using the choke to run better, etc)

    Could be an air leak. Look into info on doing a leak down test.
    ...
  9. Replies
    3
    Views
    101

    Re: Keihin carb parts

    I have Genuine Keihin brand carb kits in stock here, and would Match Steve's price of $65 on e-bay.

    https://www.watcon.com/fuel-system/carburetor-fuel-pump-rebuild-kit/keihin-carb-kit

    I ALSO...
  10. **SALE** Cold Fusion / Weber Billet throttles.

    Billet Cold Fusion / Weber throttles on sale. Normally $80, now $70 + ship. Both silver, and black. 6mm threads for Yamaha (No cable adapter needed) and 10mm threads for Kawasaki.
    ...
  11. Replies
    0
    Views
    58

    F.S. New WORX Scoop Polaris Octane

    Worx intake scoop Polaris Octane, increase water flow, and reduce cavatation. Also increases control, and turning capability, with little to no loss in top speed. New, original retail was $200,...
  12. Replies
    0
    Views
    48

    F.S. NEW R&D Ride Plate Polaris SL

    R&D "Speed" plate for Polaris SL series sit down PWC.

    New, retail Price was $190.00, on sale now $149 + ship. I Only have ONE of these left..... First to order gets it.
    ...
  13. Replies
    0
    Views
    106

    F.S. New X2 Drive shat

    New X-2 shafts are now back in stock. (Those who have been waiting have been shipped out, thank you)

    $299 + ship

    https://www.watcon.com/x2-drive-shaft
  14. Replies
    0
    Views
    87

    New X2 Drive shafts

    New X-2 shafts are now back in stock. (Those who have been waiting have been shipped out, thank you)

    $299 + ship

    https://www.watcon.com/x2-drive-shaft
  15. Re: Possible Charging issue. Strator / Regulator?

    13.5 volts should be good. Not sure where you are reading this is low?

    Check your battery voltage while sitting. A fully charged battery should be at or near 12.5v. Now start your machine, you...
  16. Replies
    46
    Views
    1,550

    Re: Any old school members still around here?

    I remember rec.sport.jetski
  17. Replies
    4
    Views
    3,247

    Re: 2018 Watcon Lake MI Surf Ride.

    Hello Steve.

    I am sorry, I am NOT doing a surf ride this year....
  18. Replies
    2
    Views
    278

    Re: Troubleshooting

    SBT (owner of this site) Has their own version of the Can Doo. Maybe that is what you are thinking of?
  19. Replies
    1
    Views
    131

    Re: Troubleshooting

    Why do you not want a Can Doo? It is what we use here, and works very well. (I have Candoo Pro) They also have excellent customer service.
  20. Replies
    5
    Views
    172

    Re: WTB UMI 3-button holder

    https://www.watcon.com/handling/handlebar-switch-holders/umi-switch-holder
  21. Re: F.S. New HD Cable conversion kit, 6mm for Blaster 1

    Yes, I can send you just the bracket. Best to call my shop. 608-743-1305
  22. Replies
    4
    Views
    159

    Re: reed cages 89 650 sx

    Throttle cable should go right up the pole.
  23. Replies
    1
    Views
    162

    Re: Battery Isolator

    Depending on the SeaDoo, some are easy to get to the cables. Just take the negative cable off. You can adapt a boat/marine type battery cut off switch, but in my experience they do not last long in...
  24. Replies
    4
    Views
    159

    Re: reed cages 89 650 sx

    You are fine.
  25. Re: Looking for kawasaki 750 single 44/46 mikuni intake manifold

    Single SBN intakes for the Kaw 750 are no longer available new.

    We have adapter plates that allow you to run a SBN carb on your stock Keihin intake $35 + ship.
    ...
  26. Replies
    4
    Views
    219

    Re: Hello Another New Boy Here

    Welcome to the site.

    Remove the cable at the rear of the ski, and turn pump nozzle by itself. I have seen corrosion in the bushings (From the machine being left in the water, especially salt). ...
  27. Re: Newbie from Australia - (2005 FX160HO)

    Welcome to the site.
  28. Replies
    3
    Views
    209

    Re: Please help

    Your ski does not sense any vibration.

    If your pump has bad bearings / and is locking up, that will rob h.p. and may make it run poor. I doubt though it would limit it to 3000 rpms....

    Sounds...
  29. Thread: Newbie

    by john zigler
    Replies
    2
    Views
    183

    Re: Newbie

    Get a shop manual for your ski. It will go over all needed maintenance, etc.

    Sea-Doo 2 stroke machines are known for fuel related issues. Go through the fuel system COMPLETELY. Rebuild the carb,...
  30. Re: Opinion Needed. Fuel pickup forJS550 Westcoast Large Capacity Tank.

    Fuel line zip ties. Or stainless worm gear clamps.
  31. Replies
    3
    Views
    231

    Re: Reed Valves

    If reeds are bad, you will see fuel spray, backwards up into the carb throat while the ski is running, and reved up.
  32. Re: 97 sl700 runs poor. Some times hits a wave and takes off.

    Are your primer fittings mounted low, like on the intake manifold? There should not be enough vacuum at the top of the carb to "pull fuel through your primer". I have seen this when people put the...
  33. Re: 97 sl700 runs poor. Some times hits a wave and takes off.

    You may be in limp mode. Some Polaris skis will go into limp mode if they are low on oil, fuel, overheat, etc. Not to say you are, but "if" your machine thinks you are, it then puts it into limp...
  34. Replies
    7
    Views
    381

    Re: 550/800 conversions stock pump

    13/18 Skat c-75 large hub swirl cut back 6mm, that I then re-worked / tuned.

    Pipe was a highly modified 650 pipe on a port matched (to cly, and pipe) manifold.

    Honestly I could care less...
  35. Re: 97 sl700 runs poor. Some times hits a wave and takes off.

    Welcome to the site.

    DO a spark test, you may be running on only one cylinder. Polaris 700's are known for ignition related issues.
  36. Replies
    3
    Views
    277

    Re: JS440 Running hot ??

    Sounds normal. It is July, water temps are warm, and the Kawi's do tend to run warm.

    Shoot a temp gun at it. What temps are you running? (Just touching the water is not accurate.)
  37. Re: 96' Polaris SL700 Engine install/compatibility with 96'SLT700? Please help

    700's are all the same, Polaris industries twin cylinder engine, black with read head shells.

    Fuji engines were blue, and are triple cylinders. A Fuji would be a 650, 740, or 780. Parts do not...
  38. Replies
    5
    Views
    412

    Re: New to this page

    That was me on your other thread.

    Timing is easy, it is just a plug.

    Jetting carbs is easy as well. I have notes on what we use here for builds. I sell jetting kits $40 per carb.

    You can...
  39. Replies
    7
    Views
    381

    Re: 550/800 conversions stock pump

    I too have done many conversions.

    Back in the mid 90's I had a dual carb 750, 210psi, ported 750 in a 550. Custom SKAT impeller. Ski ran 54 mph on GPS, and pulled OK. This exact engine was an...
  40. Replies
    3
    Views
    222

    Re: 90 JS500SX Crank rebuild

    Personally, I am no longer able to get quality crank parts to rebuild a 550 crank. We have been using NEW ADR cranks in all builds here. I can supply you one.

    Also have crank seals, 1211 case...
  41. Replies
    46
    Views
    1,550

    Re: Any old school members still around here?

    Most of you guys are newbies...…

    Lol Zig
  42. Replies
    13
    Views
    567

    Re: Finally tuning js440/550?

    Try 105 pilot, 110 main.

    You are rich on the main jet.
  43. Replies
    6
    Views
    300

    Re: New to modding, pipe?

    Agreed, good impeller, and larger exit nozzle. TBM Scoop is also a good upgrade. Especially in choppy water.

    Factory pipe limited pipe will give you good gains. I would also advance timing,...
  44. Replies
    4
    Views
    346

    Re: 93 Yamaha vxr pro starting issue

    Could be start relay, start/stop switch, connections where the start/stop switch harness is at the e-box, etc. You need to do some testing with a multi meter, and see.
  45. Replies
    5
    Views
    412

    Re: New to this page

    Welcome Joe.

    The SXR is a great machine, and there are many things you can do to it to improve, and still be reliable.

    Need to know your goals to make recommendations. Do you want handling?...
Results 1 to 45 of 8804
Page 1 of 196 1 2 3 4
Powered by vBadvanced CMPS v4.2.0