Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: restosud; Keyword(s):

Page 1 of 49 1 2 3 4

Search: Search took 0.17 seconds.

  1. Re: SXR 800 Carbon Fibre Ride Plate - Questions.

    flexy will make it hit the pump.
    had a worx alloy plate that would bend and wedge itself in the hull,never happened with other plates. should be stiff enough not to flex unless you design the flex...
  2. Replies
    5
    Views
    472

    Re: R&D pole spring tensioner question

    you have an sxr one.
    sxi looks like jim li's
  3. Replies
    7
    Views
    498

    Re: 1993 750 SX: 2 Stroke Oil Recommendation

    previous owner was using walmart pennzoil and ski still runs good. what does that tell you?
  4. Replies
    17
    Views
    4,602

    Re: Pro Watercraft pump stuffers

    of course they would!
    fact is it doesn't do a thing for performance.
  5. Thread: 550 steering

    by restosud
    Replies
    6
    Views
    739

    Re: 550 steering

    have a bearing system for you.brand new .
  6. Replies
    3
    Views
    1,129

    Re: Hydroturf Standup Rails

    you can glue and roll it under the rail but heat it up at the sharp bend so it doesn't want to pull away too much.
  7. Replies
    2
    Views
    477

    Re: SXI Hull Repair 😬😬

    looks as if it was already repaired.
  8. Replies
    0
    Views
    214

    sxr 1500 new riva high flow intake kit

    selling a new riva high flow air intake kit for all years sxr 1500. comes complete including the little vent filter (not pictured).
    brand new as in never used.
    selling because dealer will void...
  9. Thread: 95 750 sxi

    by restosud
    Replies
    3
    Views
    572

    Re: 95 750 sxi

    very easy. get a service manual on line and follow the procedure.
  10. Replies
    4
    Views
    438

    Re: WTB 750sx Steering Subplate

    have a billet with quick steering plate. purple.
  11. Replies
    5
    Views
    1,266

    Re: 440/550 D&G Pipe reviews?

    as wmazz says and try and get the longest pipe available. shorties never worked .ski motors are torque engines,not high hp screamers .
    the cast aluminum westcoast with added 3" to the cone worked...
  12. Replies
    16
    Views
    2,321

    Re: First attempted start of JS550

    timing light and yes, prime fuel system.
  13. Re: complete long or short block 1999 Kawasaki STX 1100 engine

    have 99 and 97 1100 engines ready to go.can sell short block or with mag,flywheel and starter and exhaust pipe and intake manifold
  14. Replies
    2
    Views
    277

    Re: JS550 Stator Mounting plate

    got the manifold i bought 07/02 shipped out?
  15. Replies
    6
    Views
    480

    Re: Ported Alfa 440 550 exhaust mani

    pm sent
  16. Replies
    1
    Views
    265

    Re: WTB: 66E motor

    have all the parts to build one with wdk 927 kit and girdle head and new oem crank.
  17. Replies
    1
    Views
    1,570

    Re: Crankshaft collar and o ring

    look on the collar for a recess for the oring.
  18. Replies
    2
    Views
    374

    Re: 87 Kawasaki Js300 spark arrestor

    yes.
  19. Re: WTB: Kawasaki 900STX Top-End or Complete Engine - West Michigan

    have 2 1100 engines.
    much more power than 900's
  20. Replies
    13
    Views
    878

    Re: 1991 550SX or not?

    cranks are interchangeable. wider stud spacing on sx reed engine so base and head gaskets will not work on your engine. you need normal js 550 gaskets for your engine.
  21. Re: WTB: Kawasaki 900STX Top-End or Complete Engine - West Michigan

    yup. plenty of threads on it in this forum. you will need to repitch or change impeller or find an 1100 pump assembly and use an 1100 cdi.
  22. Re: WTB: Kawasaki 900STX Top-End or Complete Engine - West Michigan

    want to put an 1100 in it?
  23. Re: Best way to properly install coupler on conversion X2 driveshaft?

    hand tight as much as you can and the engine and pump will do the rest.
  24. Re: 750 SXI Pro taking on water after seal replacement.

    shaft bearing mounts to an aluminum plate glued to hull. known to corrode and pull away from bulkhead.
  25. Replies
    3
    Views
    581

    Re: SXR 800 pump section needed

    750 is the same.
  26. Replies
    8
    Views
    278

    Re: Accel 750 lightweight charging flywheel

    looks like a total loss wheel. can you post pic of other side?
  27. Replies
    1
    Views
    424

    Re: Novi 48 Carb Rebuild Kit

    yes,correct kit.
  28. Re: 81 JS440 with 550 motor with stuck impeller where to start?

    hex on prop means it's a 550 pump.

    if liner is rubbing impeller in some spots,it's because the corrosion has pushed it out. not much you can do other than changing the inlet pump shoe.
    with some...
  29. Re: Js550 swap, 750 ebox with 650 motor and electronics

    won't work.different wiring and ignition pick up on 750 vs magneto setup on 650.
  30. Re: Looking for big hub swirl 750/sxr 800 impeller

    75 or 83mm?
  31. Replies
    8
    Views
    415

    Re: 750/800 kawasaki solas 12 vane pump

    no need. you're doing fine by yourself with solas lol......
    temper,temper.
  32. Replies
    2
    Views
    271

    Re: Looking for stock Yamaha head

    $20 ship
  33. Replies
    1
    Views
    213

    Re: Looking for OEM exhaust for 701 Superjet

    couple here. $40 + ship
  34. Replies
    8
    Views
    415

    Re: 750/800 kawasaki solas 12 vane pump

    if you have to ask,stick to the solas....
  35. Replies
    8
    Views
    415

    Re: 750/800 kawasaki solas 12 vane pump

    have skat setback
  36. Re: Do I need to get a block off plate to run premix?

    you can cut off or grind the drive tab on the pump so it will not spin and possibly seize.
  37. Replies
    6
    Views
    481

    Re: Wtb. Waterbox lower pad for sxiPro

    can sell you a piece of 1"thick hydroturf hard foam and make it yourself. oem pad was 1" thick also.
    it's the stuff used to make pads for lay down pipes and pole pads.
  38. Re: Wtb any 750sx performance/handling goodies

    have rad dual intake and 48 novis or full spectrums.also new kommander billet head and girdle.
  39. Re: Grease or oil Steering cables to extend life

    you can try oiling but not normally needed. takes a while for the oil to reach throughout.
  40. Thread: spark plugs

    by restosud
    Replies
    5
    Views
    1,904

    Re: spark plugs

    the world has become so lazy that the plugs have to be pre-gaped for us!
  41. Replies
    5
    Views
    967

    Re: 66e electronics

    no.
  42. Replies
    5
    Views
    484

    Re: kawasaki sxr800 stock intake grate

    found the grate. thanks
  43. stock oem kawi 800sxr main jets and springs

    looking for the 2 stock mikuni carburetor main jets (152.5) or 155 and the 2 black stock needle and seat springs.
  44. Replies
    5
    Views
    484

    Re: kawasaki sxr800 stock intake grate

    pm sent.
  45. Replies
    5
    Views
    484

    kawasaki sxr800 stock intake grate

    looking for a stock kawi sxr800 intake grate.
Results 1 to 45 of 2199
Page 1 of 49 1 2 3 4
Powered by vBadvanced CMPS v4.2.0