Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: super_kev; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    1,129

    Re: Yamaha SUV Service Manual

    Thanks, I'll take a look at that. But if anyone has an actual SUV service manual that would cover other areas, that'd be great too.
  2. Replies
    2
    Views
    1,129

    Yamaha SUV Service Manual

    Does anyone have a service manual for a 2002 Yamaha SUV? Buddy of mine picked one up with a "locked motor" (supposedly some water came out of the cylinders when plugs were pulled out, per...
  3. Replies
    27
    Views
    19,682

    Re: Far norcal riders??

    Bumping an old thread here, but ya'll still riding up in the Redding area? I've got a few Ventures and Raider; and will probably go to Shasta (usually Lakehead) sometime later this month or next.
    ...
  4. Replies
    15
    Views
    20,016

    Re: PWC Trailer Winch post where to find?

    Bumping a old thread here, but did anyone ever figure out who made that nice pwc winch stand/roller/plate steel combo in the picture by OP? I need three of them. Parker Yamaha (where picture is...
  5. Re: Yamaha Venture - Gas in bottom of hull on hot day (photos)

    True, I won't ride it, I'm not an idiot believe me; I've seen what happens and I won't do it. But I'll try the air trick; so that check valve is a one-way valve into the tank, right?
  6. Re: Yamaha Venture - Gas in bottom of hull on hot day (photos)

    So I checked the vent separator "tube" and cleaned it out with brake cleaner (pulled the smaller tubes off, cleaned out the large tube and reseated the lower rubber stopper), but it appeared to be...
  7. Re: Yamaha Venture - Gas in bottom of hull on hot day (photos)

    How do you clean them or check? Or do you just cut them off and put a new vent of some sort on the tube?
  8. Yamaha Venture - Gas in bottom of hull on hot day (photos)

    So I've got two '95 Venture 700s. Both have full tanks, but one of them is leaking gas out from what looks like around the black rubber tank top on a hot day and I've got almost 1" of gas on the...
  9. Re: Need gasket help with dual SBN44 rebuild (WaveRaider, WaveVenture 700)

    Found a Venture and a Raider manual - both show that there is the o-ring, then clear plastic diaphragm, then gasket above that, so it is not sandwiched like the above photo (gasket/plastic/gasket,...
  10. Need gasket help with dual SBN44 rebuild (WaveRaider, WaveVenture 700)

    So, I just picked up a 94 Raider and 95 Venture 700, and I'm working on rebuilding the Venture carb setup first. I have new 1.5 needle/seat and rebuild kits (gen Mikuni), and the Mikuni rebuild...
  11. Re: New Member - PWC is in my future - need some guidance

    IMO, go with the mid-90s 2-strokes (Wave Ventures are great and family friendly). Lighter, easier to work on and cheaper than 4-strokes.
  12. Replies
    2
    Views
    385

    Re: Wave raider Riva red exhaust issues

    Try to pull the hoses off and clean them and the waterbox out - sometimes mud daubers can get in there and create a real mess.
  13. Re: 1996 Waveraider 2 cyl- low oil flashing power loss

    Hey Ryan,
    You have a two stroke, which does not have crankcase oil. So, if you have the low oil light, depending on where the sensor is, you could be "ok" for a bit, or dangerously low. If you run...
  14. Replies
    874
    Views
    328,685

    Re: POST YOUR CUSTOM PAINT

    Yes thanks, I was just going back a few pages (started at 1-20, then jumped here and there) and saw a response of yours. So with prepping - hit with 100-200 grit, prime, base and finally clear and...
  15. Replies
    874
    Views
    328,685

    Re: POST YOUR CUSTOM PAINT

    To those of you who have painted your ski, how do you take care of the hull side? Some of these are painted all the way down, some just to the waterline with white factory gelcoat on the ride area. ...
  16. Re: Wave Venture 700 - Left turn loss of power, fuel tank leak

    Checked, rubber was tight - ordered new one for the tank.

    I just ordered some SBN rebuild kits and some new needles/seats as well. thanks!
  17. Replies
    3
    Views
    632

    Re: Repair 750ZXI Hull

    Great, thanks for the responses. I'll try the 1708 and see what happens. Can I just sand the entire hull with 80 grit and repaint? What should I do with the existing areas of what looks like...
  18. Wave Venture 700 - Left turn loss of power, fuel tank leak

    Hi folks,
    I just picked up a '96 700 Wave Venture, and I notice that it'll stay same engine speed/throttle when whipping it hard right (or, as much as you can whip a 3-seater), but cranking hard...
  19. Replies
    3
    Views
    632

    Repair 750ZXI Hull

    Hi folks,
    I just got into PWC sport, and picked up a Yamaha Venture 700, runs great, and a 750ZXI, which I believe is more of a lemon than I realized. Not having seen ZXIs before, I thought the...
Results 1 to 19 of 19
Powered by vBadvanced CMPS v4.2.0