Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: cleetus; Keyword(s):

Page 1 of 27 1 2 3 4

Search: Search took 0.10 seconds.

  1. Replies
    3
    Views
    493

    Re: Picked up a 2007 Kawasaki ultra 250x

    you could also part it out
  2. Re: 2000 Kawasaki Zxi 1100 Catastrophic engine failure

    You probably did nothing wrong, but an old ski needs the crank/seals/bearings replaced eventually even if it doesn't have a ton of hours... these thing turn and 6000 rpms and tiny pitting on bearings...
  3. Replies
    1
    Views
    1,072

    Re: vx 1100 service manual

    I need one too
  4. yamaha VX Overheat, low pisser flow. Pipe near front of ski getting hot

    So my relatively new to me vx 2007 1100 overheat warning came on yesterday. Ski looks very well maintained, guy said he flushed it every time, and its all ocean around here. I towed it back with...
  5. yamaha VX Overheat, low pisser flow. Pipe near front of ski getting hot

    So my relatively new to me vx 2007 1100 overheat warning came on yesterday. Ski looks very well maintained, guy said he flushed it every time, and its all ocean around here. I towed it back with...
  6. Replies
    23
    Views
    6,205

    Re: crank seals, right?

    Could your pulse line be clogged/split.. I'm no expert but same motor had a split in the line that I couldn't see and it would run bad at mid throttle, at higher rpms it seemed fine.. when you take...
  7. Replies
    2
    Views
    1,184

    Re: 96 XP with double Karavan trailer for sale

    sweet cheap ride for someone...
  8. Replies
    1
    Views
    1,054

    Re: A Yama day ride in Sweden

    love it
  9. Replies
    8
    Views
    2,023

    Re: Overheating 1100 ZXi--how do I flush?

    they usually clog at the 90 up front where the temp sensor is.. mine was like concrete in there.. take it apart and clean it out..
  10. Replies
    1
    Views
    1,012

    Re: Got a pair of '06 F12x 10 days ago

    I am shocked that these things can run well with some of the problems I've seen.. and I don't trust dealerships to be pros and fix things the right way all the time...
  11. Re: Kawasaki STX 15F - Not winterized water in oil

    yes to the above... small things first.. then the big... if you cracked something there should be more problems then a bad idle
  12. Re: Towable floats & tubes--good ride being pulled by a Jetski?

    skis pull tubes easy, but it will make the ski corner different. you could pull 3 tubes and people with your 100hp+ski
  13. Replies
    7
    Views
    1,395

    Re: 2015 Kawasaki 15f acting up

    Have you inspected your pump? rope can get tangled in there or some fishing line... You don't really need to change your plugs every year.. What does your air filter look like? try running it with...
  14. Replies
    9
    Views
    1,884

    Re: hull repair - fiberlgass

    What type of epoxy? and if the fiberglass is still wet nothing will bond to it… also very thin skim coats don't adhere well without sanding.. post some pictures of before and after and I can advise...
  15. Replies
    3
    Views
    1,457

    Re: Used Yamaha Ski Recommendation

    don't know if they will really handle the chop that much better... the new Yamaha 1800's will... and all the heavy kawasakis and seadoos… you really need to try them I have a vx1100 and its ok in...
  16. Re: 1999 Tigershark 770r will not accelerate over 3100 rpms

    ok so then im guessing its in your pump, or the overheat sensor..can you crank the impellor by hand? using the coupler with the plugs out? or will it turn over easy with the starter and the plugs out?
  17. Re: 1999 Tigershark 770r will not accelerate over 3100 rpms

    Hi bud.. so check the compression.. that is the first step and should let you know if the engine internals are ok..
    The "running away is not good and usually cause by a lean condition, which means...
  18. Replies
    6
    Views
    2,940

    Re: Submersible Trailer Lights DIY?

    So basically the Led ones should last a long time.. the lights usually go out because of the hot bulb cracking in the cold water.. (and of coarse corrosion).. I don't think they can be sealed enough...
  19. Re: Spacing between Jetskis PWC on Double Trailer - Refurbishing trailer

    So that's how I made mine, and I have 4 trailers in the yard, one double, and nothing is the same on any of them... I tried to measure the skis (2 Yamaha vx's almost 42" wide), and go from there.. My...
  20. Re: Spacing between Jetskis PWC on Double Trailer - Refurbishing trailer

    559352559353559354
  21. Re: Spacing between Jetskis PWC on Double Trailer - Refurbishing trailer

    its late here I will measure in the am..
  22. Re: Spacing between Jetskis PWC on Double Trailer - Refurbishing trailer

    I am welding up a new trailer in the garage right now.. and I had a hard time deciding how far to put them apart.. I spaced the bunks 26" apart (center to center) on each side of the trailer, and...
  23. Replies
    3
    Views
    424

    Re: 98 gp1200 broken stabilizer

    post a picture and help us all out understand the problem..
  24. Replies
    2
    Views
    2,210

    Re: Powder coating stuff

    looks really nice and its such a tough finish.. you will get lots of business..
  25. Re: F12X goes into limp mode at WOT for greater than 15 minutes, but otherwise does n

    so are you regularly back flushing your ski on a hose?
  26. Looking for a stx15f somewhere close to the canadian border

    I want a Kawasaki stx 15f or 4 stroke ultra..
  27. Re: 1998 Tigershark TS1000R Carburetor Needle & Seat

    haha.. I cant see the damn stamps either.. and make sure you check all the jet sizes, some carbs the rear is a little bigger.. (i think)
  28. Replies
    2
    Views
    351

    Re: 2019 GP1800R SVHO 30 hour part out

    wow, no warranty? or owners fault? sad to see a expensive new ski just finished..
  29. Replies
    4
    Views
    810

    Re: Tigershark PJ640

    so sbt offers and exchange, and if your crank and bearings are wet that motor is toast.. take it back to the builder..
  30. Replies
    2
    Views
    512

    Re: F Glass Repair Help/Advice

    carve out the cracks a little, drill tiny holes at the end to stop the crack from running.. Use epoxy, fiberglass/Kevlar/carbon fiber cloth and go over, then redrill the holes
  31. Re: 1996 Monte Carlo 770 - Bendix not engaging - help with replacing the starter??

    That could be an air leak.. First check and make sure all your cables are staying where they should be and not opening the throttle.. If you spray a little starter fluid by your crank seal and the...
  32. Re: 1996 Monte Carlo 770 - Bendix not engaging - help with replacing the starter??

    so you can pull it all off in the hull but its a pain.. the Bendix may free up but once they get corroded it only a matter of time till its done.. there are videos on youtube, you use a "harmonic...
  33. Re: Quarantine has me rebuilding my first yamaha 760- any videos? my first rebuild

    https://www.youtube.com/watch?v=ZkvNLuzW2Aw

    got a great video
  34. Replies
    10
    Views
    3,593

    Re: '96 Seadoo XP Limited/Rec boat

    Such a fun little ski..
  35. Re: Quality carbon fiber fabric online supplier/retailer???

    I think us composites is where everyone gets it
  36. Replies
    9
    Views
    1,849

    Re: Powder coating jet pump parts

    That's a crap job.. Thing with powder is it should really coat well...
  37. Quarantine has me rebuilding my first yamaha 760- any videos? my first rebuild

    Hello. I have rebuilt carbs and top ends, but this is my first time rebuilding any 2 stroke bottom end. I see plenty of videos on youtube, but they don't have much detail, and i'm still a little...
  38. Re: Hit rock scraped into the fiberglass!! NEED HELP ON REPAIR!!

    I leave it in the garage with a 100 w bulb by it, its warm but no flame, a few days later I would just patch it..
  39. Replies
    6
    Views
    1,722

    Re: 1996 Seadoo XP/X4 Limited

    yeah such a fun reliable ski..
  40. Replies
    6
    Views
    2,962

    Re: Today was a sad day...

    yes to the above.. just from the business standpoint- train a guy and have him keep a loyal customer... seems like a lot of business these days don't get it...
  41. Re: Tiger 770TSL how do I remove the driveshaft and coupler

    is there a flat spot on the driveshaft that you can put a wrench on? I thought there was on mine.. I think it is torqued to 90lbs so its tough to break loose.. the coupler is threaded onto the...
  42. Replies
    16
    Views
    2,616

    Re: How do I remove this front pump housing

    yes to the wood block and some smacking..
  43. Replies
    7
    Views
    8,762

    Re: 2020 Jet Ski STX160 personal watercraft

    MAN I LIKE THEM... I have always wanted a stx15f.
  44. Replies
    24
    Views
    17,712

    Re: 1997 tigershark montego 1050 build

    I like it man!
  45. Re: Like New Worx Yamaha VXR/VXS/VX110 Intake Grate comes with pump seal kit $179 shi

    why didn't you like it?
Results 1 to 45 of 1210
Page 1 of 27 1 2 3 4
Powered by vBadvanced CMPS v4.2.0