Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: doodah; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.07 seconds.

  1. Re: '02 900 STS wiring schematic/diagram needed

    Since I'm considering selling, I wanted to check thoroughly. As expected, bad solenoid.
    Runs well, again.
  2. Re: '02 900 STS wiring schematic/diagram needed

    Thanks. I have checked the control box. No water, but obviously has had condensation moisture in there.
    Now I have to trace wires, check for corroded connections, etc. Thus, I feel the need for a...
  3. '02 900 STS wiring schematic/diagram needed

    My ski not used (stored w/cover only) for 2 years. Unusual snow and ice last winter apparently was too much. For East TX!
    No start. New battery, not a sound. I have a repair manual for earlier 900...
  4. Replies
    1
    Views
    1,848

    Re: '02 900STS (JT900B4) Won't crank/not a sound

    I located images from replacing solenoid (2010). Both attach (together) at reg.
    Replaced regulator and solenoid. Still nuthin'.
    After some tracing, I "might" have found the problem.
    Doesn't the...
  5. Re: '02 900STS multimeter crazed lens - can't see if power is "on"

    This is result after 1 pass of 3000 grit. A couple passes with rubbing compound and I'll be satisfied.
    560917
  6. Replies
    1
    Views
    1,848

    '02 900STS (JT900B4) Won't crank/not a sound

    I checked battery, connections, etc. Opened the control box. The voltage regulator is swollen/cracked.
    After removing reg. I found a broken red (16/18 gauge) wire. Broken end in area of the...
  7. Re: '02 900STS multimeter crazed lens - can't see if power is "on"

    I bought a 3M Windshield Restoration Kit -39008.
    I am through 2nd step w/ 900 disk. Then a bigger ski problem hit me. It's definitely working. Will provide final thoughts in a couple days.
  8. '02 900STS multimeter crazed lens - can't see if power is "on"

    Ski doesn't make a sound. Good/charged battery.
    Can't tell if on/off switch is active!
    How can I clear up the lens?
  9. Re: '97 1100 STX starter doesn't disengage after engine stsrts

    I put in another new solenoid. Checked new starter. Traced and checked continuity of all wires in start/stop circuit.
    Cleaned the start and stop button contacts. Visually checked all wires in...
  10. Re: '97 1100 STX starter doesn't disengage after engine stsrts

    I checked the solenoid. As I expected, it is open.
    The gear assy. I purchased did not have the washer supplied. I used the original. Cleaned up and lightly lubed.
  11. Re: '97 1100 STX starter doesn't disengage after engine stsrts

    I could still hear the starter motor was engaged. At least making the normal "whining" sound.
    When I first tried to start it, I made it spin over a few times. Released start button and starter...
  12. '97 1100 STX starter doesn't disengage after engine stsrts

    In previous post, I addressed solenoid (broken case) problem.
    Next find was a locked up starter bendix (gear assy.). Replaced it and new starter motor.
    Everything re-assembled. Motor turned over,...
  13. Replies
    3
    Views
    750

    Re: '97 1100 STX start solenoid Positive lead

    whazguude, thanks for the reply. I solved that problem with the new small harness.
    I'll start a new post with a new, more perplexing problem.
  14. Replies
    3
    Views
    750

    Re: '97 1100 STX start solenoid Positive lead

    An update - I tried a sewing pin/steel wire from a steel cable/etc. Saw a UTube video and ordered a set of recommended "tools".
    Nothing worked. Luckily there's a regulator lead (small harness)...
  15. Re: Looking for a Shop manual for a 2002 900 STS

    I bought my Kawasaki service manual on eBay. PART No. 99924-1205-01
    I found out you also need the service manual supplement to cover parts of the '02 900 STS.
    Part No. 99924-1242-52
  16. Replies
    3
    Views
    750

    '97 1100 STX start solenoid Positive lead

    Replacing bad solenoid -I followed the same procedure I've done before.
    Last step in removal is to unplug the start switch lead. The wire came loose from the terminal.
    And terminal is in the...
  17. Replies
    6
    Views
    1,185

    Re: 2002 STS Torque Specs.. please help

    I've made this mod on a number of Kawa's. Running 50:1
    Advice I got here, long ago.
  18. Replies
    5
    Views
    583

    Re: oil block off - '92 650 TS

    Does it have a raised boss to locate the oring? Made of? How much?
  19. Replies
    5
    Views
    583

    oil block off - '92 650 TS

    This ski last ran in 2011, in storage since. In surprisingly great condition.
    I'm replacing fuel lines, etc. Oil supply line to manifold already in pieces.
    Block off kits I've found are supplied...
  20. Replies
    25
    Views
    2,947

    Re: new to me 2002 900 STX

    Acceleration is smooth to top end. Carbs were set to factory specs.
    I live on a small (1325 acre) lake. So top end, etc. isn't important to me.
  21. Replies
    25
    Views
    2,947

    Re: new to me 2002 900 STX

    I have an '02 900STX. Acquired from my Grand daughter. It was hard to start, she was impatient. Replaced some wires once. Then had to replace complete harness.
    I installed a primer kit and "canned"...
  22. Replies
    1
    Views
    734

    '97 - 1100STX gas/oil warning light

    This is a neighbors ski with recent re-manufactured engine. Intermittent warning light problem. It smoked and ran poorly.
    Owner had been told "don't trust oil pump" so he ran mixed gas. He asked me...
  23. Replies
    1
    Views
    613

    Re: knee pad removal - '02 STS 900

    Well, I pried enough to tell it definitely wasn't stuck to fiberglass.
    Removed the front seat bracket, which also released the bottom of the center compartment.
    Barely visible was a through bolt...
  24. Replies
    1
    Views
    613

    knee pad removal - '02 STS 900

    I have "finally" got all mounting nuts/washers removed. But pad doesn't want to come off.
    Middle of the narrow portion (center of hull) is stuck tight or being held by something. ???
    I have new...
  25. Replies
    2
    Views
    929

    Re: Kawa 900STS (JT900B4) vs 900STX (JT900A1)

    My question is. Are these models electrically and mechanically the same?
  26. Replies
    2
    Views
    929

    Kawa 900STS (JT900B4) vs 900STX (JT900A1)

    I ordered a service manual advertised as for JT900A/B. I received manual -
    front cover says 900STX and back says "model application -1997 JT900-A1".
    Vendor rep. was clueless if it's the correct...
  27. Re: '02 Kawa STS900 - surges @ near to full throttle

    Thanx, Myself,
    Didn't think to try either. I'll put her in the lake and try it this w/e.
  28. '02 Kawa STS900 - surges @ near to full throttle

    I have installed primer and oil block off. Ran great May to late August.
    Got some bad gas or dirty gas container. I changed filter and added about 2/3 full tank of clean/mixed gas.
    It runs at idle....
  29. Replies
    5
    Views
    908

    Re: '02 900STS - oil pump block off - question

    Thanx, OldGuy!
  30. Replies
    5
    Views
    908

    Re: '02 900STS - oil pump block off - question

    I have installed the block-off kit. What is the correct ratio for gas mix? 50:1 ??
  31. Replies
    5
    Views
    908

    '02 900STS - oil pump block off - question

    Have the kit, no instructions. Only ? I have is -
    do I have to do anything to the body harness leads for the oil level/warning?
  32. Replies
    2
    Views
    556

    carb primer kit '02 900STS

    Are there any negatives to installing one??
  33. Replies
    4
    Views
    508

    Re: '02 900STS - fuel tank removal

    Thanx, Grumpy!!
  34. Replies
    4
    Views
    508

    Re: '02 900STS - fuel tank removal

    Thanks, Grumpy. To do that, I need to remove the strap hold downs (keep from tearing up the foam) don't I?
  35. Replies
    4
    Views
    508

    '02 900STS - fuel tank removal

    Well, dis-assembly has gone well; 'til now. Manual says disconnect/remove (all the obvious).
    Remove the tank. NOT, the way I see/tried it.
    Tank is in a foam cradle, which is in a recess in the...
  36. Replies
    0
    Views
    501

    '02 900STS - strange find

    I seem to have a fuel flow problem. New fuel pump didn't fix.
    So I've pulled the motor and tank, to check switch etc. and replace hoses.
    I found a hole (appx. 1/4 ") in the hull floor, obviously...
  37. Replies
    9
    Views
    1,434

    Re: '02 900STS - pump won't pull gas

    Well, guess I'm back to the orig. post. :( Pulse hose is firm, but pliable.
    Thanx to PEVO's info - '03 fact. man. and '01 supplement is on the way. BUT, sure wished someone'd been down this road...
  38. Replies
    9
    Views
    1,434

    Re: '02 900STS - pump won't pull gas

    I just looked at the pulse hose, end to end. Still has same nylon fact. clamp at motor end. - (electrical ty-wrap). Looks okay, but I'll remove spark plug post and get "hands on".
    RE: STS/STX...
  39. Replies
    9
    Views
    1,434

    Re: '02 900STS - pump won't pull gas

    That's the way it's connected. The tube to center fitting goes around front of pump, and disappears between carbs and engine. I assumed :( it went to the carbs.
    Sooo, I still have a problem. I've...
  40. Replies
    9
    Views
    1,434

    Re: '02 900STS - pump won't pull gas

    [QUOTE=hyosung;3613142]do you have the fuel hoses on there correct fittings ..... Good question! I hadn't tried to run it, since a dealer mech. replaced CDI and rebuilt carbs. That was September -...
  41. Replies
    9
    Views
    1,434

    '02 900STS - pump won't pull gas

    Ski won't start, unless i shoot gas into the carbs. I've replaced the fuel pump. I can blow thru both hoses. Owners manual suggests a plugged tank vent hose, possibly. Apparently the hose is routed...
  42. Replies
    0
    Views
    578

    What carb is on my '92 TS 650

    The carb needs rebuild. It cranked/ran (briefly) on the trailer. But won't idle/get full power on the water.
    Ski is on a lift and can't get it to ramp 'til next week.
    The model number is JF650AE1...
  43. Replies
    1
    Views
    589

    hose/etc. attachments - inside hull

    What's a good cleaner/adhesive for these?? Most of them are loose & hanging, on both my Kawa's.
  44. Replies
    5
    Views
    1,238

    Re: '02 900STS fuel problem

    Chris - By pulse line, is that the same as the return line?
    I pulled both hoses to the tank, blew thru them. Reconnected and left filter up high (where I could see it). Fuel into filter And...
  45. Replies
    5
    Views
    1,238

    Re: '02 900STS fuel problem

    Well, - new fuel pump/filter, has 4 gal. gas. I cut a short piece off each hose to the pump, to insure tight fits.
    Still, gas doesn't draw into the filter/carbs! ???
Results 1 to 45 of 54
Page 1 of 2 1 2
Powered by vBadvanced CMPS v4.2.0