Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: BoardMe; Keyword(s):

Search: Search took 0.00 seconds.

  1. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    Okay. Thanks a lot! Maybe get my ski running for Christmas. ��
  2. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    Okay got me a brand new OE carb. Does anyone know the pop off spec?
  3. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    And pop off pressure spec. Please ����
  4. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    Found needle and seat. 1.5. Spring??
  5. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    Okay. So I’m trying to buy a new carburetor. Found my manufacturer. Bought a manual but it doesn’t have a pop off spec for the needle and seat. Does anyone know what size needle and seat was OEM,...
  6. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    I haven't had the overtemp sensor hooked up the last three times I've ran it. I got the high jet backed out almost two turns now and the low jet like little over a half turn. Got it running in the...
  7. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    Im going to set up a test "tank" in my garage so I can run it under load without travel back forth to the lake. I thought I a pretty smart guy, but this has me scratching my head bad...
  8. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    Update. Vent check valve is good I think. Holds pressure in the tank, but lets air in if negative pressure. I still think the gas tank is good and fuel lines, but that is next to pull engine and...
  9. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    I can't see why it would start and run fine for a bit if it was carburation???
  10. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    Lets say it is bad spark. Stator and trigger ohm out exactly what the manual specs. I've replaced the Ignition coil but the old one ohmed out right on as well. Magneto seems to have good strong...
  11. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    Damn I forgot to check spark when it dies...But no exhaust leak. Put an inline electric fuel pump on supply to make sure had good fuel pressure. Disconnected the temp sensor. Manual said it should...
  12. Re: Warms up after a couple minutes, bogs down, and wont stay running.

    No. But I can usually get it to start again, but nothing past a crappie idle.
  13. Warms up after a couple minutes, bogs down, and wont stay running.

    Hey Guys! Got me an ole Tigershark Montego Deluxe '95 640. Bored it out. Rebuilt the carb. ohmed out the stator. Found a short in the power supply wiring at the 15amp breaker. Pressure tested the...
  14. Replies
    3
    Views
    10,054

    Re: Freshly rebuilt 640 engine

    Do you have the CDI box and regulator for this engine?
Results 1 to 14 of 14
Powered by vBadvanced CMPS v4.2.0