Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Jobs

» wallpapers

Search:

Type: Posts; User: banjomaniac; Keyword(s):

Page 1 of 12 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    7
    Views
    408

    Re: F12X slow crank/no crank intermittent

    I had to ski I bought doing something very similar and after a few days of messing with it checking everything it ended up being the ground wire had burned against the block but you couldn't see it...
  2. Re: Honda Aquatrax Impeller stuck due to corrosion

    Keep in mind the turbo and the non turbo are different. I've got my old turbo pump listed and it's been ground a few times but I listed it for parts, the impeller and shaft and probably bearings are...
  3. Re: Honda Aquatrax Impeller stuck due to corrosion

    I just did this with my F12 non turbo, there are 4 bolts holding the pump on to the ski, first you have to pull the reverse bucket off disconnect your steering cable and your reverse bucket cable...
  4. Replies
    13
    Views
    460

    Re: Over torqued or Stripped spark plug?

    If you are unsure I'd take to a good mechanic or an engine shop and they can fix the spark plug threads. I don't know if I would trust any of the aftermarket thread repair kits they have for spark...
  5. Replies
    13
    Views
    460

    Re: Over torqued or Stripped spark plug?

    lmao!
  6. Re: F12X tracking or sliding on rough water

    Thanks blitzn, I'll check it hopefully this weekend if it's not raining. actually my plan is to put both skis in the water, I have a F12 2005 model non-turbo and then just compare how they both...
  7. Replies
    6
    Views
    296

    Re: Honda R12 Overheats

    I had a hose clamp come lose when I first got mine put back together but it was gushing a pile of water but if you're going to find the leak I would at least run it for a few seconds and look around ...
  8. Re: F12X tracking or sliding on rough water

    No water when I got back to the ramp, I'm the only rider 225 lbs. I'll get back out maybe today and see how it does.
  9. Replies
    6
    Views
    296

    Re: Honda R12 Overheats

    Does it overheat and shut down on the hose too?

    Banjomaniac
  10. F12X tracking or sliding on rough water

    Not sure how to describe this but here on the White Oak River about 5 miles from Bogue Inlet is where I ride. When It's windy and a little rough the ski seems to feel like it's gonna turn with every...
  11. Re: 03 F12X turbo stuck after setting all winter

    Spatera, what kind of performance increase does the solas intake grate and impeller give?

    Banjomaniac
  12. Replies
    22
    Views
    954

    Re: Yamaha Wave Venture no spark...again

    To be clear, you pulled the white black wire and it wouldn't start? I had the same symptoms and went around it running then it wouldn't start and back and forth, it ended up being the switch. I tried...
  13. Re: 03 F12X turbo stuck after setting all winter

    Thanks Spatera, when I get the intercooler pulled and get the computer loose I'll look at that as an option. I bought my wife a 2005 F12 non-turbo and haven't had a chance to look at it yet but it...
  14. Re: 03 F12X turbo stuck after setting all winter

    Actually you can sort of get to the bearing by popping the top oil line off which I did as soon as I pulled it off oil started running out which was a good thing but I stuck a rolled paper towel...
  15. Re: 03 F12X turbo stuck after setting all winter

    Because I can't get to the other side without taking it apart and I own stock in CRC:)
  16. Re: 03 F12X turbo stuck after setting all winter

    I rode for about an hour Monday and it was windy and choppy on the White Oak River here in Swansboro but the ski ran great.

    Banjomaniac
  17. Replies
    0
    Views
    185

    2003 F12x air box upgrade

    I've got an air box and all the parts from an 04 aquatrax F12X and need to know if anyone has details or can post pics of how they mounted the computer under the glove box. I'll be doing this in a...
  18. F12X complete water Stator (Jet Pump) working for parts $100

    This is my old jet pump off my F12X, I've ground the sleeve a few times where it was swelled but it's usable or has a good shaft and impeller. $100 plus shipping.

    Banjomaniac in NC

    549259
  19. Re: 03 F12X turbo stuck after setting all winter

    Sprayed it a bunch Saturday and after it sat a couple hours and I dug out the mud dauber nest from the pee hole I ran it on the hose a few minutes and it seems good now. Thanks Duane! I'll try to get...
  20. Replies
    22
    Views
    954

    Re: Yamaha Wave Venture no spark...again

    Did you figure it out?
  21. Re: 03 F12X turbo stuck after setting all winter

    Checked it after work today and it's stuck again, didn't take much to move it but it's not spinning free so I guess I'll have to pull it. Anybody know what the small Phillips screw on top is or...
  22. Re: 03 F12X turbo stuck after setting all winter

    New manifold, shouldn't be water other than the antifreeze in the water muffler. I sprayed another crap ton of 656 and spun it a few times with a socket, seems good now. I was trying to think if I...
  23. 03 F12X turbo stuck after setting all winter

    Had this ski 3 years now and this is the first time the turbo was stuck after setting all winter. I winterized the ski by the book and sprayed a bunch of CRC 656 into the turbo just like last winter....
  24. Re: Honda repairs needed - where to take them?

    I know on the turbo model Hondas there's a small hole in that rear exhaust pipe that gets plugged up and can cause the exhaust elbow to melt, that might be the same problem with your 2006 ski?
    ...
  25. Replies
    9
    Views
    769

    Re: Stress crack repair

    Thanks SuperMAC. I didnt know you were the Macsboost guy and in my state to boot! I was getting ready to change out my air box on my 03 turbocharged Aquatrax but saw that you sell a filter that...
  26. Replies
    9
    Views
    769

    Re: Stress crack repair

    I have some of the magic easy gel coat crack repair in the little squirt tube that's supossed to fix cracks or gouges. Why couldn't I use a needle or scribe to scrape the inside of the cracks to get...
  27. Replies
    9
    Views
    769

    Re: Stress crack repair

    Dang, your alot more motivated than me! Post a pic when you're done, I'd like to see it. Thanks

    Banjomaniac
  28. Replies
    9
    Views
    769

    Re: Stress crack repair

    Thanks for the reply Super MAC. So you don't think it's structural or heard anything? If that's the case I'm just going to ride it!

    Banjomaniac
  29. Replies
    9
    Views
    769

    Stress crack repair

    Anyone take care of spider or stress cracks on a boat or jet-ski, I've got a Honda aquatrax and it's got quite a few cracks showing through the gel coat I've got to get fixed not sure how to go about...
  30. Re: Catching Mahi Mahi / Dorado on a Waverunner

    I've got a Honda Aquatrax F12X. Yours must be a little more stable, mine is kinda tipsy setting still or going real slow in a turn. I want to try out the new Yamaha with the ride system, might try to...
  31. Re: Catching Mahi Mahi / Dorado on a Waverunner

    Every flipped your ski out there or rolled it pulling in a big fish? Heck, I rolled off mine setting still in the river when I leaned over a little too far lol.


    Banjomaniac
  32. Re: Air box from an 05 r12x will it fit my 03 f12x?

    Thanks Brian, do have the shroud that covers the bottom opening on the air box? I can't find that piece anywhere.

    Banjomaniac
  33. Replies
    0
    Views
    210

    Spider or stress crack repair

    Accidental double post didn't see any way to delete it?
  34. Replies
    0
    Views
    240

    Spider or stress crack repair

    Anyone take care of spider or stress cracks on a boat or jet-ski, I've got a Honda aquatrax and it's got quite a few cracks showing through the gel coat I've got to get fixed not sure how to go about...
  35. Re: Air box from an 05 r12x will it fit my 03 f12x?

    After looking online at the parts breakdown it appears it all is the same for the f12x and r12x.

    Banjomaniac
  36. Air box from an 05 r12x will it fit my 03 f12x?

    Will the air box and pipe assembly from an 05 R12X fit an 03 F12X? Can't find one specific for an F12 X that has the pipe and all the other parts plus I'll still need the shroud for the bottom.
    ...
  37. Re: How do I remove the last darn bolt on engine mount?

    It will come out just time consuming and hard. I bought some shallow sockets and I bent some wrench's just for the exhaust bolts.

    Banjomaniac
  38. Re: How do I remove the last darn bolt on engine mount?

    There's a good guide on YouTube I think it's jet ski junkies they show step by step how to remove the engine from a Honda aquatrax and there's a lot of stuff has to be taken out first before you can...
  39. Re: Water in oil, 30mph max - just replaced exhaust manifold

    So when you said you put on a new exhaust manifold, did you pressure checked the old manifold and you're sure it was leaking? I mean are you sure the old manifold was bad? Might be something else...
  40. Re: Water in oil, 30mph max - just replaced exhaust manifold

    When you pull the exhaust manifold look at the exhaust ports that attach to the engine, if you see white or gray discolorization other than black that's probably where it's leaking. If it's leaking...
  41. Re: Water in oil, 30mph max - just replaced exhaust manifold

    I got real lucky and found one on eBay that looked brand new for $400 but that was 2 or 3 years ago. Check at Jet Ski International, they've come down in price a little, used to be like $1400 up to...
  42. Replies
    0
    Views
    201

    Honda F12X bad exhaust manifold

    wasn't sure if anyone was fixing these leaking exhaust manifolds but I have the old one off of my ski that leaked and I was going to try to cut it open and fix it but I just don't have the equipment...
  43. Re: Water in oil, 30mph max - just replaced exhaust manifold

    If it turns out the turbo is bad you'll need to check the oil line that feeds the turbo, the screen might be clogged and if you just change the turbo and don't check the screen and it's clogged...
  44. Re: Water in oil, 30mph max - just replaced exhaust manifold

    Turbo might be shot. Pull the intake hose and see if the turbo has any slop, shouldn't have any. another way I could tell my turbo was bad I fired up in the driveway reved it a couple times just a...
  45. Replies
    3
    Views
    815

    Re: Reverse modification

    I replaced the metal bushing with the kit from jetski international and you have to clean the actual bucket side it has corrosion buildup on it when you take it apart and with the engine not running...
Results 1 to 45 of 513
Page 1 of 12 1 2 3 4
Powered by vBadvanced CMPS v4.2.0