Search Results - PWCToday
pxctoday

» Log in

User Name:

Password:

Not a member yet?
Register Now!

» Find OEM Parts

» Hydro-Turf

Search:

Type: Posts; User: john zigler; Keyword(s):

Page 1 of 216 1 2 3 4

Search: Search took 0.49 seconds.

  1. F.S. OE Kawasaki 650 westcoast modified head

    Used Kawasaki 650 Head, modified by Westcoast. 28cc Removeable domes. According to the chart, this should net aprox 200 lbs compression @ Sea Level. Head shell and one dome are in great shape. One...
  2. Replies
    0
    Views
    160

    F.S. 08-later OE stock SJ impeller

    For sale, 08-up OE Yamaha Super Jet impeller. Take off from newer SJ. Great shape, excellent upgrade for your old SJ with aluminum impeller. $200 + ship. Please check out or site for lots more used...
  3. F.S. Westcoast Exh Manifold, KAW 650, 750, 800

    Used, Westcoast Exh Manifold. Good shape, all threads are original and good (No Heli-coils, etc) Fits Kawasaki 650, 750, and 800 engines. $275.00 + ship. Comes as shown with pipe mount bolts. Sold...
  4. Re: Bendix, idle gear starter replacment choices and options

    I Prefer OE. But We too have tried many aftermarket starters, and this is the ONLY one I'll use;

    https://watcon.com/products/yamaha-starter

    Also have new OE Bendix drives;
    ...
  5. F.S. Large Hub, 148mm Swirl Impeller 10/16 (Krash?)

    New, 148 mm 75mm Large Hub swirl impeller. Similar to a Hooker, or Skat. Brand unknown. I think it is an OE Krash impeller but not sure. New in box, measures to be a 10/16. Will work in a Yamaha...
  6. Replies
    2
    Views
    283

    Re: Need FUEL TANK for 95/96 SeaDoo GTS

    Check with your local SeaDoo dealer. If you go to them with the HIN# they can tell you if they have been replaced yet under warranty. (I doubt they have). If not, they will replace for free.
  7. Re: Kawasaki 750sxi (97) porpoise issue again

    Check to see if your hull is wet.....

    It is common on the old 750s, and can and will cause ill handling.

    Drill a couple of small holes low in the rear, and stand the ski up. See how much...
  8. Replies
    47
    Views
    1,253

    Re: 08 SJ mini project thread - Fall 2022

    Paul, if it has a RRP pole, you can add a RRP pole pad support. It is tapped at the bottom, and I then put bolts in there to "widen" the steer stop, allowing maximum steer ratio adjustability without...
  9. Replies
    6
    Views
    716

    Re: Reed or Piston Port half pipe?

    Thanks Terry.

    Correct, that pipe will work well on either 550. We do have flange mounts if you need.

    https://watcon.com/products/550-half-pipe-mount-flange

    Also have the special needed...
  10. Replies
    2
    Views
    757

    Re: 80+ MPH Yamaha GP1200r SVHO

    Thanks for watching!! I really appreciate it.
  11. Replies
    2
    Views
    757

    80+ MPH Yamaha GP1200r SVHO

    This was a fun one. 2021 Yamaha GP1800r SVHO Riva Stage one plus tune. 80+ MPH! For those that haven't yet, please check out our You Tube channel, be sure to subscribe and hit the bell for...
  12. Replies
    8
    Views
    737

    Re: Vintage Jet Skis.com Trouble

    Thanks Carter, appreciate the kind words.
  13. Replies
    3
    Views
    626

    Re: Polaris Octane Parts

    Thanks Ryan, always nice to hear from you. Your parts will ship today.
  14. Replies
    3
    Views
    626

    Re: Polaris Octane Parts

    I have one, Worx intake scoop left;

    https://watcon.com/products/octane-scoop?_pos=8&_sid=735d35a25&_ss=r

    Also have our Exh Pipe update kits;
    ...
  15. Replies
    2
    Views
    843

    Re: Sxi pro impeller with dry pipe

    Back in the day on my own SXi Pro, I ran an earlier 750 80mm nozzle with a Large, C-75 Skat Swirl 10/18. You can get a nozzle from a 92-94 750 SX, SS. Or bore yours up to 80mm.

    We now run...
  16. Replies
    11
    Views
    1,194

    Re: 2007 FXHO will not crank

    Like WFO has said.... Do you have 12 volts on at least the battery side of the relay? If you have 12 plus volts on battery side but only 3.8 on the starter side your relay is bad. "IF" you have only...
  17. Replies
    93
    Views
    8,994

    Re: Addendum to the Mikuni SBN Tuning Manual

    We run dual check valves all the time. I learned this trick many years ago from Jay @ Butch's Jet ski shop.

    Also, the valve body from the GP800 is the better design valve body.
  18. Replies
    11
    Views
    1,194

    Re: 2007 FXHO will not crank

    Relay "click" can be from a bad relay, bad battery, voltage loss from a bad connection, bad starter, locked up engine, or driveline. If you used an aftermarket, cheap start relay, it could be bad. ...
  19. Re: WTB Factory B Pipe Limited chamber (chamber only) for Superjet

    I have a new Ltd chamber.

    $500 + ship.

    Also have a new head pipe, $500

    Phone calls to the shop are best. All my contact info can be found at my Watcon web site.

    John.
  20. Replies
    10
    Views
    1,005

    Re: Looking for FACTORY HEAD PIPE

    Genuine Factory pipe for Yamaha head pipe here. Can ship today;

    https://watcon.com/products/exhaust-head-pipe-factory-pipe-b-pipe-head-pipe-for-yamaha
  21. Replies
    3
    Views
    499

    Re: Waveblaster rear exhaust outlet

    I stock here. For std 701;

    https://watcon.com/products/blaster-rear-exhaust

    Or 3" if you have done an 1100/1200 conversion;

    https://watcon.com/products/blaster-exhaust
  22. Replies
    93
    Views
    8,994

    Re: Addendum to the Mikuni SBN Tuning Manual

    Larger needle and seats can be more prone to "dribble".
  23. Re: Is the steering plate on the 86 Kawi 550 is the same as the one on a 95 sx 550?

    SX's are different. Bushings are a different size.

    I know with our own steer plates, we can run an early version on a SX, as long as you use the JS bushings.
  24. Replies
    93
    Views
    8,994

    Re: Addendum to the Mikuni SBN Tuning Manual

    You want to run a small of a needle / seat as possible to achieve desired pop off.

    Go back to 1.5's (Get NEW) Going by memory I think you want 65 gram springs. Try 70 pilots, and 150 mains. Make...
  25. Replies
    2
    Views
    292

    Re: WTB Kawasaki 550 650 conversion plate

    Original RCJS Engine conversion plate;

    https://watcon.com/collections/conversion-plate
  26. Re: BJP Prize Ski for Jet Blast 2023 - Yamaha RN Superjet

    I also have a solution for side rails for you.
  27. Re: BJP Prize Ski for Jet Blast 2023 - Yamaha RN Superjet

    Paul / Tommy, I'd be in for some parts for you guys....

    Get me the cyls, and I will bore them, and donate pistons, rings, pins, bearings, and top end gasket set.

    I will hook you up with a NEW...
  28. Re: 1994 square nose Yamaha Superjet bogs/cuts out

    Back fires can also be a timing issue. Bad CDI, loose Stator coil, sheared flywheel key, etc.
  29. Re: 1992 Yamaha Waverunner 650 LX - throttle seems limited

    I am only guessing, but I am betting you are on the rev limiter / limp mode.

    We see this quite often on the old Yamaha's, and I have seen it caused by most every item in the e-box, and even bad...
  30. Replies
    3
    Views
    456

    Re: Factory B Pipe & Stock RN Waterbox

    I have a new SJ B pipe, complete still in the box.

    It won't be cheap though. Feel free to call my shop if interested. All my contact info can be found at my Watcon web site.
  31. Replies
    2
    Views
    277

    Re: WTB Square nose Hood

    Thanks Brod.

    Bob knows us....

    Bob call me. I have a hood you can have if you are willing to drive up. (Or trade for some cyls)
  32. Replies
    3
    Views
    221

    Re: 750 SX starter solenoid

    New here;

    https://watcon.com/products/starter-relay
  33. Replies
    4
    Views
    547

    Re: 300sx/ Js ebox

    Yes, I have new, genuine Kawasaki start relays;

    https://watcon.com/products/starter-relay
  34. Replies
    0
    Views
    311

    1991 550sx walkaround video

    Thought you guys would like to see this one, Here is this week's Video, walk around of a 1991 550sx build we did here. Be sure to subscribe, thanks for watching;
    ...
  35. Replies
    4
    Views
    381

    Re: Wtb 650sx manifold for mikuni sbn 44

    New here, $190 + ship.

    Also have new carbs, (Can jet it for you) Gaskets, flame arrestors, primer kits, and more.

    https://watcon.com/products/kawasaki-650-sbn-intake-manifold
  36. Re: 1100 Kawasaki E-Box how to remove the Coil Cables ?

    You need to remove the black outer plastic caps, inner rubber gromet, plug boots, and sheath on the wire. Remove coil, and pull wires through the e-box.

    Wires are epoxied into the coils, and go...
  37. Replies
    6
    Views
    525

    Re: Wtb 300, 440, 550 ebox!

    I have a good, JS 300 e-box, from a freshwater running ski. it IS missing the start relay though. $50 + ship

    https://watcon.com/products/used-electrical-box-kawasaki-js-300
  38. Replies
    26
    Views
    1,784

    Re: Is this Engine Done?

    We have seen many bearing failures on low hour carbed engines.
  39. Replies
    26
    Views
    1,784

    Re: Is this Engine Done?

    951's are KNOWN for crank failures..... Just a FYI
  40. Re: New 750 small pin crankshaft. Flywheel doesnít fit.

    I have not personally done this and do not know, but it looks as if others say they have.....
  41. Re: New 750 small pin crankshaft. Flywheel doesnít fit.

    Correct, early 750 cranks have a "shoulder" and different taper than later. They also had 18mm coupler thrreads.
  42. Re: Installing Westcoast Pipe, what adjustments are needed?

    Your lines are melting from heat / lack of water. I am betting you have blockage in the pipe water passages.
  43. Replies
    9
    Views
    1,979

    Re: 550/750 ebox relocation

    Yeah, sorry our bracket only works with the SX driveline. (IE later 550sx, OR "IF" you are running a 750 pump conversion you will then run the X2 shaft and it will work). The "JS" drive bearing...
  44. Replies
    9
    Views
    1,979

    Re: 550/750 ebox relocation

    Depending on what e-box he is running, we have a mount plate to put a stock 750 ss, ssxi, sts box in the place where the stock 550 was;
    ...
  45. Replies
    4
    Views
    547

    Re: 300sx/ Js ebox

    I have one, $50 + ship. It came from a running machine, and is complete except start relay.

    You can see / order here;

    https://watcon.com/products/used-electrical-box-kawasaki-js-300
Results 1 to 45 of 9704
Page 1 of 216 1 2 3 4
Powered by vBadvanced CMPS v4.2.0