pxctoday

  • rsg1963

    There is no available content written by rsg1963
  • Recent Article Comments Widget

  • Recent Blog Posts

    Moeboatin

    Seadoo Boat / Wont run over 5000 rpm

    I have a 97 challenger with a 787 single motor.
    Have done leak down test and replaced seals as needed.
    Carbs are done, fuel lines changed, cable adjusted.
    Will not do more than 20 mi hour and only...

    Moeboatin 08-10-2018 01:24 PM
    ham7

    Complete Sea-Doo HX does anybody need parts

    Interested in black rubber pieces by seat, knees and gas tank/neck fill. Price on hood and black hood

    also, carbs clean? Price?

    text/call 765-517-1663

    ham7 08-08-2018 11:31 PM
    Mdileva

    2004 Honda Aquatrax Jet Ski, HELP

    Bought this jet ski 2 years ago have not been able to ride it yet. I have found that no one wants to work on it because it's a Honda. First place I took it too, it would start up, them after running...

    Mdileva 08-08-2018 05:16 PM
    Dodge0ram8

    I have a 1987 wetbike

    I just purchased it at a auction it didnít run when I bought it pulled engine redid all fuel lines including one in the tank (reason for not running ) but now itís got a new issue once I start it and...

    Dodge0ram8 08-06-2018 10:50 PM
    Cocoloco48

    What would you do? R&D intake grate for vx110 problems

    Hello I have a 2007 Yamaha VX Cruiser is only doing 45 MPH I wonder if I replace the Intake Grate,Replace the Impeler into. Rivas Solas and I use the Seal Kit my Sky is going to be a little bit...

    Cocoloco48 08-01-2018 03:52 PM
  • Recent Forum Posts

    aquanut

    Re: Pump spinning clockwise but not counter clockwise

    Just read your post right after i posted this, So you think its a bent shaft causing this ?

    aquanut Today, 08:33 AM Go to last post
    milmo1

    Re: New Jetskier

    Yow!
    Easy guys. No need to start a battle of the keyboards.
    Having had 2 power boats for years, I am all too familiar with the B.O.A.T. acronym.

    milmo1 Today, 08:33 AM Go to last post
    aquanut

    Re: Pump spinning clockwise but not counter clockwise

    Well i took the impeller back off this morning to take a look a look and figured it would be near impossible to get the pump pulled up off the shaft because

    aquanut Today, 08:32 AM Go to last post
    Spim

    Re: The Question Game

    Mostly clean undamaged std OEM stripped of non running yami, doo's, the occasional cow, tossed on a shelf, could not convince myself to throw away.

    Spim Today, 08:29 AM Go to last post
    Myself

    Re: Pump spinning clockwise but not counter clockwise

    The pump shaft should slide right in with the only resistance felt when it passes through the front seal.

    Myself Today, 08:29 AM Go to last post