pxctoday

  • Pyro412

    There is no available content written by Pyro412
  • Recent Article Comments Widget

  • Recent Blog Posts

    Moeboatin

    Seadoo Boat / Wont run over 5000 rpm

    I have a 97 challenger with a 787 single motor.
    Have done leak down test and replaced seals as needed.
    Carbs are done, fuel lines changed, cable adjusted.
    Will not do more than 20 mi hour and only...

    Moeboatin 08-10-2018 01:24 PM
    ham7

    Complete Sea-Doo HX does anybody need parts

    Interested in black rubber pieces by seat, knees and gas tank/neck fill. Price on hood and black hood

    also, carbs clean? Price?

    text/call 765-517-1663

    ham7 08-08-2018 11:31 PM
    Mdileva

    2004 Honda Aquatrax Jet Ski, HELP

    Bought this jet ski 2 years ago have not been able to ride it yet. I have found that no one wants to work on it because it's a Honda. First place I took it too, it would start up, them after running...

    Mdileva 08-08-2018 05:16 PM
    Dodge0ram8

    I have a 1987 wetbike

    I just purchased it at a auction it didnít run when I bought it pulled engine redid all fuel lines including one in the tank (reason for not running ) but now itís got a new issue once I start it and...

    Dodge0ram8 08-06-2018 10:50 PM
    Cocoloco48

    What would you do? R&D intake grate for vx110 problems

    Hello I have a 2007 Yamaha VX Cruiser is only doing 45 MPH I wonder if I replace the Intake Grate,Replace the Impeler into. Rivas Solas and I use the Seal Kit my Sky is going to be a little bit...

    Cocoloco48 08-01-2018 03:52 PM
  • Recent Forum Posts

    Gray Devil

    Bullet Racing V1 SXR 1100

    For Sale:

    2011 Bullet Racing V1 hull
    Kawasaki ZXi 1100 triple
    ADA Head
    Rick Roy billet handle pole with billet bracket

    Gray Devil Today, 03:20 AM Go to last post
    Tynewberry

    Re: 650sx part out

    I’ll take the wc tank and pick ups. Pm sent

    Tynewberry Today, 02:40 AM Go to last post
    Tynewberry

    Re: X2 lanyard faceplate

    Negative, should bolt up to the backplate from the stock start/stop switch. Just recently did this to my 90 x2 with no problems

    Tynewberry Today, 02:26 AM Go to last post
    STX1100_dwestep

    Re: 2001 1100 STX-Di failure... please help..

    Got your email, thank you.. I need until this Friday before I can buy it.. thank you so much!

    STX1100_dwestep Today, 02:00 AM Go to last post
    liame124

    X2 lanyard faceplate

    Picked up a lanyard face plate for my ski just to be safe. Am I going to need to change any wiring?? I have a 1991 x2

    liame124 Today, 01:42 AM Go to last post