PWCToday - PhilthyPhil
pxctoday

  • PhilthyPhil

    There is no available content written by PhilthyPhil
  • Recent Article Comments Widget

  • Recent Blog Posts

    hagedorn45

    hagedorn45

    Not getting fuel to carbs but it gets fuel to fuel filter. 96 wave blaster 2 new filter

    hagedorn45 Yesterday 06:43 AM
    Jakeevans420

    650sx Stator Check

    Jakeevans420 06-16-2019 07:36 PM
    Jakeevans420

    650sx Pump Info

    Jakeevans420 06-13-2019 10:46 PM
    Pgwaterman

    Rebuilt carb same issue

    Pwc members, I just rebuilt 1997 wave venture 760 carbs still having same issue of ski will start and run fine but then when it sits for a hour it will not start unless I put fuel into the carb then...

    Pgwaterman 06-13-2019 06:49 PM
    Kcarr624

    Purchasing 1999 seadoo GTX Limited and 2000 Yamaha xl1200

    Can anyone give me some common problems they come across With these two waverunners? Iím buying them off an old man who hasnít used them in 2 years so theyíve been sitting. Engines on the skis donít...

    Kcarr624 06-12-2019 07:14 PM
  • Recent Forum Posts

    vegasphotog

    Best Hull Cleaner?

    I have searched this forum and not really found a thread that helps. Lake Mead has super hard water...my neighbor and previous long term resident

    vegasphotog Today, 10:53 AM Go to last post
    seniormints

    Re: compression issue on new (group k) rebuild

    I am in no way saying they made a mistake. I am just confused that I have such low compression, that the stock compression was higher.

    It

    seniormints Today, 10:50 AM Go to last post
    Stxray

    Stx1100 blown engine -cause?

    I am new to this forum. Bought a mint 1997 STX1100 with only 80 hours on it. I put 20 hours on it and ended up blowing the side off the middle piston.

    Stxray Today, 10:35 AM Go to last post
    mcn6

    Re: 750 temp

    Take it back to where you ride and back it in to the water leaving it tied down to the trailer. Start the motor to load the pump and remove any cooling

    mcn6 Today, 10:35 AM Go to last post
    daniel1123

    Re: 1994 SC 650 starter solenoid

    Thanks for the feedback. I thought I wired it the same way as the original. But if I did notm,c oudl that have damaged in internally? Should I go to my

    daniel1123 Today, 10:29 AM Go to last post