pxctoday

  • 1957Dave

    There is no available content written by 1957Dave
  • Recent Article Comments Widget

  • Recent Blog Posts

    Moeboatin

    Seadoo Boat / Wont run over 5000 rpm

    I have a 97 challenger with a 787 single motor.
    Have done leak down test and replaced seals as needed.
    Carbs are done, fuel lines changed, cable adjusted.
    Will not do more than 20 mi hour and only...

    Moeboatin 08-10-2018 01:24 PM
    ham7

    Complete Sea-Doo HX does anybody need parts

    Interested in black rubber pieces by seat, knees and gas tank/neck fill. Price on hood and black hood

    also, carbs clean? Price?

    text/call 765-517-1663

    ham7 08-08-2018 11:31 PM
    Mdileva

    2004 Honda Aquatrax Jet Ski, HELP

    Bought this jet ski 2 years ago have not been able to ride it yet. I have found that no one wants to work on it because it's a Honda. First place I took it too, it would start up, them after running...

    Mdileva 08-08-2018 05:16 PM
    Dodge0ram8

    I have a 1987 wetbike

    I just purchased it at a auction it didnít run when I bought it pulled engine redid all fuel lines including one in the tank (reason for not running ) but now itís got a new issue once I start it and...

    Dodge0ram8 08-06-2018 10:50 PM
    Cocoloco48

    What would you do? R&D intake grate for vx110 problems

    Hello I have a 2007 Yamaha VX Cruiser is only doing 45 MPH I wonder if I replace the Intake Grate,Replace the Impeler into. Rivas Solas and I use the Seal Kit my Sky is going to be a little bit...

    Cocoloco48 08-01-2018 03:52 PM
  • Recent Forum Posts

    BigPappa

    Re: carbonfiber x2 build

    I just read this whole thread in one sitting. Beautiful work!! That first ride is going to be a sweet one after all the work you have put into it!

    BigPappa Today, 01:44 PM Go to last post
    Dave in DE

    Re: GP800R will not stay running

    Ski4me, I leave my lines a little extra long. That gives them room to shrink. I check them down by the pump. Just to see if there plyable and replace

    Dave in DE Today, 01:39 PM Go to last post
    Rushford_Ripper

    Re: Sbt= JUNK

    Junk oil block off plate? That's a pretty straight forward part that I'm sure the issue was a installation/user error.

    Rushford_Ripper Today, 01:23 PM Go to last post
    hyosung

    Re: Loose steering column

    the bushings are worn out,have someone at a local machine shop cut the housing so as bearings can be fitted.
    i did mine years ago and it is still

    hyosung Today, 01:22 PM Go to last post
    Rushford_Ripper

    Re: Loose steering column

    Yes they are all sloppy

    Rushford_Ripper Today, 01:20 PM Go to last post