• dowellj

    There is no available content written by dowellj
  • Recent Article Comments Widget

  • Recent Blog Posts


    Kawasaki 750 sxi pro jetski ebox wiring

    Hello sorry to bother everyone I was just wondering if anyone have a wiring diagram for a kawasaki 750 sxi pro jetski ebox. I have taken mine out to give it a clean and forgot to take some photos of...

    Blue33 Yesterday 07:47 PM

    1999 Seadoo speedsterSK

    I have a Motor when in the water it wount go over 4500 rpm with out shurging. replace fuel pump,new fuel filter.cleaned filter inside carberator. when not in the water it runs up to 6000 rpm and hold...

    pmherder Yesterday 01:35 PM

    Fuse Issue?

    I recently acquired a ‘96 Sea Doo SPX. The previous owner wasn’t sure what the issue was (he said it just stopped on him in the middle of the lake one day) and sat on it for several years, so I got...

    gwhitley4395 Yesterday 12:37 PM

    yamaha startup troubleshoot

    how can i check if the starter is good on my 99 yamaha gp1200... doesnt want to start on the ignition side but jumps with a screwdriver on the relay.

    mikeberra 08-16-2018 03:39 PM

    Seadoo Boat / Wont run over 5000 rpm

    I have a 97 challenger with a 787 single motor.
    Have done leak down test and replaced seals as needed.
    Carbs are done, fuel lines changed, cable adjusted.
    Will not do more than 20 mi hour and only...

    Moeboatin 08-10-2018 01:24 PM
  • Recent Forum Posts


    Re: Need help with 1987 js550

    Good answer!

    mcn6 Today, 01:36 PM Go to last post

    Re: Js440 mods inquiries.

    It’s a brand new pjs prop, haven’t really heard of them so I don’t know if it’s worth the purchase. Anyone use those before?

    Matt_teix Today, 01:24 PM Go to last post

    Re: The Question Game

    How about peaches AND pears?

    Cliff Today, 01:21 PM Go to last post

    Re: Does this look right to you???

    I got it. Thank you for your help. I lightly put vice grips on the C clip then with a bit of twisting and muscle the hat went over the C clip.

    mrwhipper Today, 01:06 PM Go to last post

    Re: Buying New Advice/General First timer ?s

    For first timers, if you are not sure how much you will ride or what kind of machine you want, it might be better to go down the path of buying a used

    LakesideRec Today, 12:59 PM Go to last post