how to get graphics to fit...

kawi105 · 02-14-2010, 01:44 AM

on the rear half of the SXR.

I was putting graphics on today, and theres like 4 different curves to combat. How do you deal with this?

I got one side done and it looks good from 4 feet away, but i want this side a little better.

Mr Bojangles · 02-14-2010, 10:41 AM

You need to heat and strech them carefully. Wet the sufave down with soapy water, the place the graphics down, then heat. The soapy water allows you to remove the graphics without messing them up

kawi105 · 02-14-2010, 02:32 PM

thanks, i did everything you said cept heat. ill try that today.

Mr Bojangles · 02-14-2010, 03:29 PM

I forgot to add, make solute not to over heat it or it will bubble or tear. Use a hair dryer or I have just did it out in the sun in Florida. Once your done and if you have little bubbles, just put it in the sun and use a needle and pop them and flatten them out and you will be set