Shred Master Vintage 650sx Are Back

Shred Master Performance · 10-23-2007, 04:17 PM

We are now casting and shipping the Shred Master 650sx for the first time in years due to many customer requests. Many other Shred Master vintage models some All-In-One piece grate/ride plate are now available to order and being shipped too many we also have not been made for many years.

THE ORIGINAL KAWASAKI 650SX SHRED MASTER RIDE PLATE
All-In-One grate/ride plate>>> One piece foiled intake grate, and "V" bottom ride plate on an extended tail. Designed to tremendously enhance the turning and riding capabilities of the 650SX in all water conditions. Eliminates porpoising! Hull pitch angle is controlled by an increasing "V" bottom surface on a long tail ride plate. This maintains the hulls pitch-planning angle which allows the hull to ride flatter and more parallel to the water although with the bow still slightly up angled. Advance intake grate hook-up with a very deep and forward extending primary scoop along with a fully foiled patented intake grate design, which allows a fluid stream of water to flow directly to the center of the impeller un-aerated. No square 2 x 4 block of wood blades design to create water resistance, or trailing edge air traps bleeding air into the pump!

Check Them Out
Bob Morgan Shred Master Performance
www.shred-master.com

650SX >>>>>>>>> http://shred-master.com/prod06.htm

X2 >>>>>>>>>>>> http://shred-master.com/prod09.htm

440-550 JS-SX >> http://shred-master.com/prod07.htm

750SX-SXI >>>>> http://shred-master.com/prod05.htm

Blaster >>>>>>>> http://shred-master.com/prod08.htm

ZXI >>>>>>>>>>> http://shred-master.com/prod03.htm

GP >>>>>>>>>>>> http://shred-master.com/prod02.htm

Ultra 130-150 >>http://shred-master.com/prod01.htm

Starting this fall many of these vintage ride plate models will now only be sold off-season (September to February). This is needed not to slow our production speed down with tooling changes for a short run of ride plates during the main season with new ride plates being release next year.

We have now concluded bring all our Vintage ride plate back into production. Next new ride plate will be the Shred Master STX-R / 12-15F and should be in production by the first of the year.

Kawtipper · 10-23-2007, 04:37 PM

Best 650sx intake/ride plate you can get in my opinion.
Any sx riders looking to drastically improve your handeling....get one of these. I don't push too much stuff, but when I rode a Kaw and picked up one of these....I was thoroughly impressed!!