JD

Has anyone tried to cram a blaster mod pipe into a square nose?
Will it fit?

thanks for your help.

Matt_E

It will fit. You may need to reshape the gastank a bit with a heat gun (empty, of course), and perhaps dent the chamber a bit. But it fits.

__________________
If I sound like a moron, it's only because I haven't typed enough words yet.

Jetworks....Blowsion....Superfreak!....Thrust Innovations

JD

Cool, thanks!

T-Bone

Do you use the same header (blaster) pipe combo?

__________________
SUR#82
pwctoday....its like working with my brothers kids.

Matt_E

Yes. Just the chamber is different.

__________________
If I sound like a moron, it's only because I haven't typed enough words yet.

Jetworks....Blowsion....Superfreak!....Thrust Innovations

Art_Maybee

Heat on an empty gas tank is a LOT worse than heat on a FULL tank.
If you are going to heat the tank to shape it, you might want to try filling it with water first. Don't apply heat to an empty tank.

Matt_E

Empty and dried out for a couple of days (in my case), I should add. :razz:

__________________
If I sound like a moron, it's only because I haven't typed enough words yet.

Jetworks....Blowsion....Superfreak!....Thrust Innovations

blaster94

If you fill the tank with water all your gonna do is heat the water up. Use a heat gun on an empty tank and take it easy not to over heat the plastic.

__________________
94 Blaster x2 94 SJ 04 R12X
Click this=>https://www.awahq.org/p/joinNow.php And Join!

Water Worx

I didnt have to heat the tank to clear,just a small dent in pipe will do & maybe covered with a piece of hydroturf.

You will need to put a BIG dent on the side of the chamber to clear the side wall or grind the wall.

bad93blaster

i would run the exhaust off my truck through the tank before id heat the tank

__________________
there is no fun playing stock