cascade

Hi just got my new faceplates for my x2 and 550sx. Got the x2 swapped no problem. But cant figure out how to get the switch face swapped out on my 550sx. Guessing it slides sideways but seems awful tight and I dont want to break it! There a trick?

motoman96

it just slides out. Its supposed to be a tight fit so water doesn't get in there. You took the screw off right?

__________________
94 FX-1: ADA girdled head with 35cc domes, 0* freestyle bars, AC aluminum handpole, Coffman sizzler exhaust, Skat 18/23 impeller, Jet Dynamics intake grate and rideplate, ODI grips, UMI finger throttle, MSD enhancer
active member of the CCC (cupcake cult).

cascade

Dont mess with me man! I was just out looking at that switch for like 20 min and there isnt any screws!
And I tried just sliding it off both ways pushing as hard as I could didnt budge.

motoman96

have you taken the switch assembly off the bars?? There is a screw on the bottem, that will allow the two halves to come apart. You then slide the faceplate off an put the new one on.

__________________
94 FX-1: ADA girdled head with 35cc domes, 0* freestyle bars, AC aluminum handpole, Coffman sizzler exhaust, Skat 18/23 impeller, Jet Dynamics intake grate and rideplate, ODI grips, UMI finger throttle, MSD enhancer
active member of the CCC (cupcake cult).

cascade

Screw was buried under some old sealant. Thanks!

motoman96

yup, idk about the white stuff. But its in the center.

__________________
94 FX-1: ADA girdled head with 35cc domes, 0* freestyle bars, AC aluminum handpole, Coffman sizzler exhaust, Skat 18/23 impeller, Jet Dynamics intake grate and rideplate, ODI grips, UMI finger throttle, MSD enhancer
active member of the CCC (cupcake cult).