SLT 700 Polaris

bullitt1939 · 02-21-2010, 10:45 PM

I just picked up a 700 SLT Polaris. It has not been run in two years. What is the best way to go about cleaning the fluids out and replacing with new ones? What all should I do before even attempt starting this ski? I know I will have to drain gas for sure, but I am not sure how to go about this. Any help would be appreciated. Thanks.

bullitt1939 · 02-21-2010, 10:49 PM

Here is a picture of it.

SteveTec · 02-22-2010, 08:01 AM

Does it crank over, if not pull the spark plugs and turn the engine by hand - remove the drive shaft guard and turn the shaft, it should be free moving if so then start by doing these steps.
Drain the Fuel tank first, use a fresh battery and check each cyl for good compression using a good guage, 140 psi is ideal but depending on the guage it may vary. Check to see that you have good spark then remove and check the carbs and rebuild them if there in need of it.
These are basic steps to insure it will run properly.
Good Luck

payasito · 03-05-2010, 12:47 PM

yea just follow this steps he is rihgt

blegan · 03-21-2010, 10:29 PM

Is this a 750slt or 700sl Never mind the photo explained it all. I never knew they manuf. a 700slt

Keith447 · 03-25-2010, 06:49 PM

Quote:

Originally Posted by bullitt1939

I just picked up a 700 SLT Polaris. It has not been run in two years.

...What all should I do before even attempt starting this ski?...

I just bought a Polaris PWC - what should I do?
What to do to get it running, keep it running, and avoid potential damage