08-12-2009, 06:16 PM
|
#1 |
| Frequent Poster
Join Date: Aug 2007 Location: raleigh nc
Posts: 250
| Finally got a Blaster need a little help to get right
Hi All,
Finally found a Blaster locally in good shape. (will post pic when get her going)
It's a 94 the guy sold it because she won't open up.
I put it in and it ran great for about 5 or 600 feet then dropped into limp mode and I had to ease her back and on the trailer. I was thinking bad temp sensor...but the block felt hotter then my Raider does after I ride it (to hot to keep hand on but touchable) so I am reluctant to pull the sensor and try her in fear of overheating the block.
Compresion is 140 and 137 in the cly's
Nothing stuck on prop or shaft.
Blows water from dischage on side when under power. (did notice puff of black smoke from it when put back on trailer just figure dirty exhaust).
Looking over her I can't see anything that jumps out at me wrong.
Any suggestiions would help.
Also is there a way to test that heat sensor?
Other problem prop houseing shows wear ring. Suggestions on what to check beside replacing the prop and shaft? Also what props should I look at?
Thanks for your time.
__________________ Ashes to ashes,
Dust to dust,
if you don't get out and ride it,
It's just going to Rust!! 
96 Blaster
95 Blaster Mods
88 kaw 650 sx some Mods
95 wave raider dlx (mod)
98 770L cheap stock couch |
|  |
Linear Mode
