SuperDave4x4

Can someone tell me where the 3 lines that come through the hull hook up to on my engine? I know one is a bilge, but dont know which. I'm currently putting my ski back together and cant figure out where to run the hoses..

Also my ski is single cooled, NOT dual cooled.

Thanks!

__________________
1989 Kawi 440/550 - slightly modded.
1989 Kawi 650sx
1988 Kawi X2 - Coffman, Jetlyne, BCW Racing, WestCoast...getting alot of attention before summer....

http://s347.photobucket.com/albums/p449/SuperDave4x4

http://www.pwctoday.com/f72/my-100-1...ld-257418.html My slow 650sx build

turbocouperacer

blow through the one going to the rear most part of the pump, that is bilge

other one on the front of pump is for cooling, hooks to exhaust on back of engine

plug the other one

RacerX2

isnt the 3rd tube for an overboard off the head? if there are two fittings on the head, the front head outlet goes into pipe, then out of pipe to pisser.

3 tubes that go thru hull to pump area:
1. pressure line water inlet from pump goes to exhaust manifold
2. overboard from rear head outlet
3. bilge - the bigger tube of the three is the bilge

__________________