PWCToday - Blog Entries - Blogs

View RSS Feed

All Blog Entries

  1. 1995 Polaris SL650 Very Very weak spark after carb rebuild

    So last night the ski was running on a trailer but the carbs were dirty, so this morning I took the carbs off and cleaned them but after I reinstalled them to start the ski I had no spark. I used a multimeter and it shows 1.7 Volts to each spark plug. Thatís not enough voltage to see or feel spark. Iíve checked everything, all wires are connected, I see no obvious grounding issues, and all ignition coils work as they should. It ran fine yesterday, but after putting the carbs back on, nothing... ...
    Tags: no spark, polaris Add / Edit Tags
  2. Please help.. 2008 Kawasaki 250x supercharged

    Quote Originally Posted by Jermc View Post
    It was rolled a few weeks ago and now doesn't wanna run over 5-6mph. Just loses power completely when you get on the throttle. I'm not sure if we got a bad batch of gas maybe? I've changed it the battery & replaced the sparkplugs but it doesn't run any better. By chance do you know whether or not jet ski's have a "limp mode" that would maybe have to be reset if they're rolled?
  3. Honda Aquatrax F12X Power problem

    I have a 2007 F12X with 107 hrs on it. The problem I am having is when I go wide open throttle sometimes it runs the way it should and other times it does not. Sometimes it will run 6000 rpms then if I slow down and hit the throttle again it will only go to 5000 rpms. It still runs smooth but it doesn't have all of its power. I have checked the waste gate and it is moving freely and the actuator is working right with air pressure. I have replaced the turbo control sensor put in new plugs and changed ...
  4. 2002 Honda Aquatrax F12X engine died with no warnings

    Quote Originally Posted by antevi View Post
    Aquatrax F12X ran good in the water, and all of a sudden just died with no warning.
    It would start but it will only go at rough idle RPM with full throttle, before it would die again.
    I tried restarting several times but it would not go very far at rough idle, before it would quit again.
    I retrieved ECU fault codes and it shows code 25 and code 46.
    Someone suggested to get to basics, check for fuel, ignition, compression, and that the impeller spins without binding.
  5. 2005 seadoo with newly rebuild motor and sand

    I have a 2005 gti rfi that got a newly rebuilt motor installed at a shop. It never worked well then died and got washed onto Sandy beach. It was used for about 1 hour total. Sent the motor back, they said not their problem sand in the motor. Is it that easy to get sand in the motor? I could make a sandbox!
    Is it sell for parts or a repair? Btw I am in no way a mechanic. Click image for larger version. 

Name:	crankcase sand.jpg 
Views:	71 
Size:	83.4 KB 
ID:	560479Click image for larger version. 

Name:	base gasket sand.jpg 
Views:	65 
Size:	83.7 KB 
ID:	560480
Page 3 of 158 FirstFirst 123451353103 ... LastLast